|
|
Content .. 1419 1420 1421 1422 ..
Glass Preparation - Installing A Previously Installed Backlite 1. Before proceeding with the following repair proce- dure, review all warnings and cautions. (Refer to 2. Level old bead of backlite adhesive (3) to a thick- ness of approximately 1 mm (0.04 in.) and remove 3. Apply four new spacers (1) to the liftgate frame and place them 55 mm in from the window opening; 70 mm from the upper edge and 150 mm from the lower edge. 4. Install the lower spacers (2) to the backlite approximately 36 cm (1.0 in) from each side of the glass. NOTE: Remove the lower spacers 2 hours after installation of the glass. 5. Position backlite in center of liftgate opening and resting on the side and lower spacers. HB STATIONARY GLASS 23 - 197 |