|
|
Final drive mount 2. Screw studs -C- through the transmission support -A- and into the front-axle cross member. Location Explanation Type Basic value Tolerance 1 Tolerance 2 Stud on front-axle cross Tightening 20 (15 ftlb.) Nm 3. Screw fastening nuts -B- onto studs and tighten. Location Explanation Type Basic value Tolerance 1 Tolerance 2 Fastening nut on stud Tightening torque 65 (48 ftlb.) Nm Pipe holder 4. Engage pipe holder on lines. Pipe holder 5. Screw in fastening screws for pipe holder. Location Explanation Type Basic value Tolerance 1 Tolerance 2 Fastening screws securing pipe Tightening 65 (48 ftlb.) Nm 6. Remove transmission jack. Diagnostic system: reading out fault memory and activating systems Installing front final drive 1137 |