Porshe 911 (997). Manual - part 233

→ Por ello le rogamos que tras el proceso de impresión compare siempre las copias impresas con
la imagen de la pantalla. En caso de error, corrija las copias impresas de forma que se
correspondan con el contenido de la imagen de la pantalla.

Diagnostic system: reading out fault memory and activating systems

Subsequent work

1089

- Preliminary work
- Removing long halfshaft flange
- Installing long halfshaft flange
- Subsequent work

Tools

Designation

Type

Number

Explanation

socket wrench

special tool

9330

Preliminary work

Preliminary work

1. Raise the vehicle at the prescribed jacking points. →   Raising the vehicle

2. Remove left rear wheel. → 440519 Removing and installing wheel - removing

3. Remove left drive shaft. → 422119 Removing and installing drive shaft - removing

Removing long halfshaft flange

Removing long halfshaft flange

1090

Holder screw

1. Unscrew fastening screw for the coolant hose holder on the mounting saddle.

Mounting saddle screws

2. Unscrew fastening screws for the mounting saddle using socket wrench 9330.

3. Carefully pull halfshaft flange out of

transmission.

Installing long halfshaft flange

Installing long halfshaft flange

Diagnostic system: reading out fault memory and activating systems

Removing long halfshaft flange

1091

Checking halfshaft flange

1. Check halfshaft flange for burrs and sharp edges on the transmission end of the shaft and deburr if

necessary.

Note

To avoid damaging the sealing ring in the transmission, the halfshaft flange must be guided carefully into
position by hand.

2. Carefully insert halfshaft flange into the transmission.

Mounting saddle screws

3. Screw in and tighten fastening screws for the mounting saddle using socket wrench 9330.

Location

Explanation

Type

Basic value

Tolerance 1

Tolerance 2

Mounting saddle

Tightening torque

23 (17) Nm (ftlb.)

Holder screw

4. Screw in and tighten fastening screw for the coolant hose holder on the mounting saddle.

Location

Explanation

Type

Basic value

Tolerance

1

Tolerance

2

Fastening screw for coolant
hose holder

Tightening
torque

10 (7.5) Nm

(ftlb.)

Diagnostic system: reading out fault memory and activating systems

Installing long halfshaft flange

1092