|
|
Content .. 1089 1090 1091 1092 ..
B - Optical contact, black 2. Insert optical waveguide module into the connection point on the socket side. Locking spring cap of the optical contacts (on the socket side) 3. Slide the spring cap on the connection point until it can be felt to engage -arrow- . Installing optical waveguide Note Observe the general information on optical waveguides. → General information on optical waveguides - 1. Cut off the opticsl contacts of the damaged optical waveguide, isolate it and tie it to the main wire harness. Tying optical waveguide to main wire harness Note The range of spare parts available for optical waveguides depends on the vehicle equipment. Depending on 2. Route the new optical waveguide along the main wire harness, guide it through the existing cable ducts and tie it to the main wire harness using tie-wraps. Diagnostic system: reading out fault memory and activating systems Installing optical contacts on socket side 4521 |