|
|
Content .. 2037 2038 2039 2040 ..
18. CHECK WHETHER DTC OUTPUT RECURS (DTC P2444, P2445, P2446 AND/OR (a) Start the engine and warm it up. (b) Turn the ignition switch off. (c) Connect the Techstream to the DLC3. (d) Turn the ignition switch to ON and turn the Techstream on. (e) Clear DTCs (if set)
. (f) Enter the following menus: Powertrain / Engine and ECT / Utility / Air injection check / Automatic Mode. (g) Start the engine after the Techstream initialization is finished. (h) Perform the System Check operation by pressing Next. (i) After operating the AIR system, perform the following to confirm the AIR system pending codes: Press the Exit button. (j) Check pending DTCs. (k) Turn the ignition switch off. OK: No pending DTC is output. NOTICE: When performing the Air Injection Check operation after the battery cable has been reconnected, wait NG END OK REPLACE ECM 3UR-FE ENGINE CONTROL SYSTEM: SFI SYSTEM: P2444-P2447;... |