Content .. 100 101 102 103 ..

SsangYong: Engine Euro 4. Manual - part 102

CHANGED BY

EFFECTIVE DATE

AFFECTED VIN

DIAGNOSIS

CCCS

Code

Malfunction

Help

- Current vehicle speed (STICS sensor value: No. 58)

- Check the speed sensor connector

- Check the other units (ABS) that use speed signal

- Check the tail lamp relay connector

- Check the sensor values

• Tail lamp switch (STICS sensor value: No. 3)

• Tail lamp signal input status (STICS sensor value: No. 20)

• Tail lamp relay (STICS sensor value: No. 47)

- Check the tail lamp wires and connectors

- Check the sensor values

• Key reminder switch (STICS sensor value: No. 13)

• Ignition 1 switch (STICS sensor value: No. 17)

• Ignition 2 switch (STICS sensor value: No. 18)

• Ignition 1 switch (DICS-Main sensor value: No. 60)

• Ignition 2 switch (DICS-Main sensor value: No. 59)

• Key reminder (DICS-Main sensor value: No. 62)

- Check the driver side door actuator

- Check the sensor values

• Door open switch (STICS sensor value: No. 5)

• Door unlock switch (STICS sensor value: No. 22)

• All door unlock switches (STICS sensor value: No. 39)

• Key unlock (Main-DICS: No. 31)

- Check the driver side door wires and connectors

- Check the passenger side door actuator

- Check the sensor values

• Passenger side door open switch (STICS sensor value: No. 6)

• Door unlock switch (STICS sensor value: No.22)

• All door unlock switches (STICS sensor value: No. 39)

• Key unlock (DICS-Main: No. 31)

• Key unlock (Main-DICS: No. 04)

- Check the driver side door wires and connectors

- When one of the two rear seat door knobs is defective

- Check the rear seat door actuator

- Check the sensor values

• Rear door knob switch (STICS sensor value: No. 7)

• Rear right door open switch (STICS sensor value: No. 8)

• Door unlock switch (STICS sensor value: No. 22)

• Rear door open switch (STICS sensor value: No. 23)

• All door unlock switches (STICS sensor value: No. 39)

• Key unlock (DICS-Main sensor value: No. 31)

• Key unlock (DICS-Sub sensor value: No. 4)

- Check the rear seat door wires and connectors

0 X 06

0 X 07

0 X 08

0 X 09

0 X 0A

0 X 0B

Vehicle speed indicates over
0 km/h when the ignition
switch is turned off

Tail lamp turns OFF without
any signals when the tail
lamp switch is turned on

IGN 2 SW is detected as
OFF when IGN 1 SW is ON

Driver side door lock knob
does not unlock

Passenger side door lock
knob does not unlock

Rear door lock knob does not
unlock

CHANGED BY

EFFECTIVE DATE

AFFECTED VIN

DIAGNOSIS

CCCS

BRAKE

ECU

TCU

A/BAG

RK-STICS

FFH

R/SENSOR

TGS-LEVER

P/TRUNK

CCCS

STICS Input/Output Monitoring Data

12 V

GND

12 V

GND

12 V

GND

1. Sensor signal detects when the reverse gear

signal in A/T equipped vehicle

2. Ground level when not operating

3. Battery level when operating

4. This signal is used when outside rearview

mirror in DICS Main/Sub is linked with 5°C. It
is linked only when the outside rearview mir-
ror selection switch in DICS Main is not in cen-
ter position.

1. Switch signal checks the driver side seatbelt

has been fastened

2. Ground level when unfastened

3. Battery level when fastened

1. Switch that turns ON or OFF tail lamp switch

2. Battery level when tail lamp switch is OFF

3. Ground level when tail lamp switch is ON

1. When equipped with PTL, no input data is

transmitted from trunk lid open switch to
STICS

2. Battery level when open

3. Ground level when close

1. Ground level when door is open

2. Battery level when door is close

1. Ground level when door is open

2. Battery level when door is close

1. Operating conditions

• When the central door lock and unlock func-

tion is in operation

• When the doors are locked by the driver's

door lock knob

• When receiving signal from DICS via CAN

communication in auto door lock/unlock
operation at vehicle speed of 50 km/h.

2. Ground level when rear door knob is open

3. Battery level when rear door knob is close

1. Ground level when door is open

2. Battery level when door is close

1. Switch detects the parking brake engagement

2. Ground level when parking brake is engaged

3. Battery level when not operating

1. Auto windshields wiper switch. No inputs to

STICS when the vehicle is equipped with the
rain sensor

2. Ground level when ON

3. Battery level when OFF

1. Hood open detection switch

2. Ground level when open

3. Battery level when close

Reverse lever
detection

Driver side
seatbelt switch

Tail lamp switch

Trunk lid open
switch

Front left door
open switch

Front right door
open switch

Rear door knob
switch

Rear right door
open switch

Parking brake
switch

Auto windshield
wiper switch

Hood open switch

Not

detected

Unfasten

OFF

Open

Not

operating

OFF

GND

12 V

GND

12 V

GND

12 V

Detected

Fastened

Open

Operating

Open

Input

No.

Sensor value item

Information

Help

Input/

Output

CHANGED BY

EFFECTIVE DATE

AFFECTED VIN

DIAGNOSIS

CCCS

12 V

GND

1. Switch detects the trunk lid unlock from the

glove compartment

• With the power trunk: Communication be-

tween PTL and CAN

• Without the power trunk: Controlled by STICS

2. OFF: GND

3. ON: 12 V

1. Key reminder detection switch

2. Battery level when operating

3. Ground level when not operating

1. Key accessory detection switch

2. Battery level when operating

3. Ground level when not operating

1. Alternator charging detection switch

2. Battery level when operating

3. Ground level when not operating

1. Parking (P) or neutral (N) position of A/T de-

tection switch

2. Battery level when operating

3. Ground level when not operating

1. Ignition 1 detection switch

2. Battery level when operating

3. Ground level when not operating

1. Ignition 2 detection switch

2. Battery level when operating

3. Ground level when not operating

1. Windshield wiper position switch detects the

wiper position when the operation stops. With
the rain sensor equipped vehicle, no inputs
are transmitted to STICS

2. Ground level when in the original position

(operating)

3. Battery level when not operating

4. Cannot detect when equipped with the rain

sensor

1. Tail lamp operation signal (monitoring) is the

function that detects the auto light operation
of the tail lamp

2. With signal input

3. Without signal input

1. Locking door knob switch (Can be detected

when the lock switch is in operation)

2. Battery level during door unlock

3. Ground level during door lock

1. Unlocking door knob switch (Can be detected

when the unlock switch is in operation)

2. Battery level during door lock

3. Ground level during door unlock

Trunk unlock
switch

Key reminder
switch

KEY ACC switch

Alternator switch

P/N switch

IGN1 switch

IGN2 switch

Windshield Wiper
position switch

Tail lamp operation
signal

Central door lock
switch

Central door
unlock switch

Not

operating

Not

detected

Not

detected

Not

detected

Not

detected

Not

detected

Not

detected

Not

detected

No input

Not

detected

Not

detected

GND

12 V

Operating

Detected

Input

Detected

Input

No.

Sensor value item

Information

Help

Input/

Output

CHANGED BY

EFFECTIVE DATE

AFFECTED VIN

DIAGNOSIS

CCCS

BRAKE

ECU

TCU

A/BAG

RK-STICS

FFH

R/SENSOR

TGS-LEVER

P/TRUNK

CCCS

GND

12 V

GND

1. Rear left door open switch

2. Ground level when door is open

3. Battery level when door is close

1. Heating grid operation switch (Blink once when

the switch is operated)

2. Battery level when not operating (OFF)

3. Ground level when operating (ON)

1. Windshield washer operating switch

When equipped with the rain sensor,no inputs
are transmitted to STICS

2. Battery level when operating (ON)

3. Ground level when not operating (OFF)

1. Informs on armed mode

2. Electrical signals cannot be found

3. Battery level when operating

4. Ground level when not operating

1. Relay for raising the rear left power window

(The value changes when it operates within
DICS-Main)

2. Ground level when operating

3. Battery level when not operating

1. Relay for lowering the rear left power window

(The value changes when it operates within
DICS-Main)

2. Ground level when operating

3. Battery level when not operating

1. Relay for raising the rear right power window

(The value changes when it operates within
DICS-Main)

2. Ground level when operating

3. Battery level when not operating

1. Relay for lowering the rear right power window

(The value changes when it operates within
DICS-Main)

2. Ground level when operating

3. Battery level when not operating

1. Driver side door knob lock relay

(Locks all doors)

The value appears only when the relay is
connected

2. Ground level when operating

3. Battery level when not operating

Rear left door
open switch

Heating grid
switch

Washer switch

Armed mode
operation

Rear left P/WDW
UP relay

Rear left P/WDW
DN relay

Rear right P/WDW
UP relay

Rear right P/WDW
DN relay

Driver side door
lock relay

Not

detected

OFF

Operating

Not

operating

Not

operating

Not

operating

Not

operating

Not

operating

12 V

GND

12 V

Open

Detected

Not

operating

Operating

Input

Output

No.

Sensor value item

Information

Help

Input/

Output

Content .. 100 101 102 103 ..