SsangYong Korando III (2010 year). Manual - part 398

 

  Index      SsangYong     SsangYong Korando III - service repair manual 2010 year

 

Search            

 

 

 

 

 

 

 

 

 

Content   ..  396  397  398  399   ..

 

 

SsangYong Korando III (2010 year). Manual - part 398

 

 

07-4

2. MAINTENANCE

Park the vehicle on a level ground and apply the parking brake. Stop the engine and wait more than 5 

minutes.

Pull out the dipstick and wipe it with a clean cloth. Reinsert it all the way.

Pull out it again and check the oil level.

The oil level should be between the maximum (Max) mark and minimum (Min) mark on the oil 

dipstick. Oil should be replenished before the level goes below the minimum mark.

-

-

-

Engine oil dipstick

Engine oil cap

Max

Min

Replenishment

If the level gets to the lower point, open the filler cap on top of the cylinder block and add the genuine oil 

without exceeding the level of the upper mark.

Recheck the oil level after 5 minutes.

Operating vehicle with insufficient amount of oil can damage the engine. Make sure the engine oil level 

is correct and add oil if necessary.

Regularly check the engine oil level and add Ssangyong genuine engine oil if necessary.

Clean the dipstick with clean cloth so that any foreign materials cannot get into the engine.

The oil should not go above the upper mark on the dipstick.

The engine oil may be consumed more if the engine is new.

-

-

-

-

07-5

1535-01

3. LAYOUT

Oil Pump Assy

Seal Ring

Oil Pan

Bolt

Drain Plug

Bolt

Oil Pump Chain

Oil Pump Chain Tensioner Assy

1.

6.

8.

10.

11.

21.

22.

24.

Bolt

Oil Dipstick Tube Assy

Oil Dipstick Gauge Assy

O-Ring

Bolt

O-Ring

Sealant

Dust Cover

25.

31.

32.

33.

34.

37.

44.

45.

07-6

Oil Filter Assy

Oil Filter Cover

Oil Filter Element Kit

Drain Plug

1.

2.

9.

10.

O-Ring

Oil Filter Bypass Valve Assy

Oil Filter Housing Gasket

Bolt

Oil pressure switch

11.

26.

30.

31.

35.

07-7

1535-01

Oil pressure switch

1. OVERVIEW

The lubrication system supplies oil to each lubrication section to prevent friction and wear and to remove 

heat from the friction part. As the engine runs, frictional heat is generated on each lubrication section. If 

this condition persists, the bearing can be burned and stuck.

In other words, it creates an oil film on each sliding surface to convert solid friction to liquid friction in 

order to minimize wear and prevent temperature increasing on the friction part.

2. COMPONENTS

Engine oil dipstick

Oil jet

Engine oil pan

Oil pump

Oil filter module

 

 

 

 

 

 

 

Content   ..  396  397  398  399   ..