SsangYong Korando III (2010 year). Manual - part 358

12-8

2) Accelerating with the Cruise Control System

(1) While the cruise control system is running

Push up the ACCEL switch of the cruise control lever and hold it until the desired speed is reached 

without an accelerator pedal intervention.

When the desired speed is reached, release the lever.

1.

2.

(2) While the cruise control system is not running

Accelerate using the accelerator pedal over 38 km/h.

Push up the ACCEL switch of the cruise control lever and hold it.

And then release the accelerator pedal slowly.

When the desired speed is reached, release the lever.

1.

2.

3.

4.

(3) Tap-up while the cruise control system is running

Push up the ACCEL switch of the cruise control lever less than 0.5 second per one switching while 

the cruise control system is running. This is a tap-up switching.

When you operate a tap-up switching, the vehicle is accelerated by 1.0 km/h over the previous set 

speed.

If you want to accelerate to 10 km/h, operate the tap-up switching ten times without accelerating with 

the cruise control system.

1.

2.

3.

12-9

8530-00

3) Decelerating with the Cruise Control System

(1) While the cruise control system is running

Push down the DECEL switch of the cruise control lever and hold it until the desired speed is reached 

without a brake pedal intervention. But the cruise control system cannot maintain the cruise function at 

less than 38 km/h.

When the desired speed is reached, release the lever.

1.

2.

(2) When the cruise control system is not running

Push down the DECEL switch of the cruise control lever and hold it.

And then release the accelerator pedal slowly.

When the desired speed is reached, release the lever. But the cruise control system cannot maintain 

the cruise function at less than 38 km/h.
When you push down the cruise control switch, “RESUME” function starts (GSL only).

1.

2.

3.

4.

(3) Tap-down while the cruise control system is running

Push down the DECEL switch of the cruise control lever less than 0.5 second per one switching while 

the cruise control system is running. This is a tap-down switching.

 When you operate a tap-down switching, the vehicle is decelerated by 1 km/h below the previous set 

speed.

If you want to decelerate to 10 km/h, operate the tap-down switching ten times without the brake 

pedal intervention.

1.

2.

3.

12-10

4) Recovery of Set Speed (RESUME)

Even if the cruise control is cancelled, the previous set cruise speed can be recovered by pulling up the 

cruise control lever when the current vehicle speed is over 38 km/h without an acceleration intervention. 

But if you turn off the ignition switch, the memorized set speed is cleared and you cannot recover the 

previous set speed.

The resume position should only be used if the driver is fully aware of this speed and wishes to 

resume this particular speed.

12-11

8530-00

5) ECO Cruise Control

ECO cruise is ready and ECO cruise indicator on the instrument cluster comes on when pushing down 

the cruise control lever. To activate the ECO cruise mode, push down the cruise control lever again. To 

cancel the ECO cruise mode while in operation, push down the cruise control lever again. The ECO 

cruise mode is canceled and the indicator goes out.

What is ECO Cruise mode?

In this mode, the smooth acceleration to the set cruise speed can be achieved by optimized fuel 

consumption.

Control lever

ECO indicator

ON

Blinking

Push down the lever

O 

Push down it again

O