|
|
BRC-66 < PRECAUTION > [TYPE 1] PRECAUTIONS PRECAUTION PRECAUTIONS Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT INFOID:0000000005589337 The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along WARNING: • To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death in the event of a collision which would result in air bag inflation, all maintenance must be performed by • Improper maintenance, including incorrect removal and installation of the SRS, can lead to personal injury caused by unintentional activation of the system. For removal of Spiral Cable and Air Bag • Do not use electrical test equipment on any circuit related to the SRS unless instructed to in this Service Manual. SRS wiring harnesses can be identified by yellow and/or orange harnesses or har- PRECAUTIONS WHEN USING POWER TOOLS (AIR OR ELECTRIC) AND HAMMERS WARNING: • When working near the Airbag Diagnosis Sensor Unit or other Airbag System sensors with the Igni- tion ON or engine running, DO NOT use air or electric power tools or strike near the sensor(s) with a • When using air or electric power tools or hammers, always switch the Ignition OFF, disconnect the battery, and wait at least 3 minutes before performing any service. Precaution for Brake System INFOID:0000000005275105 CAUTION: • Refer to MA-16, "For North America: Fluids and Lubricants" • Never reuse drained brake fluid. splashed on painted areas, wash it away with water immediately. • To clean or wash all parts of master cylinder and disc brake caliper, use clean brake fluid. tem. • Use flare nut wrench when removing and installing brake tube. • If a brake fluid leak is found, the part must be disassembled without fail. Then it has to be replaced with a new one if a • Turn the ignition switch OFF and remove the connector of the ABS actuator and electric unit (control unit) or the battery ter- • Always torque brake lines when installing. ing rotors, after replacing pads, or if a soft pedal occurs at (front disc brake) or (rear disc brake). WARNING: • Clean brake pads and shoes with a waste cloth, then wipe with a dust collector. SBR686C |