|
|
B2601 SHIFT POSITION SEC-51 < DTC/CIRCUIT DIAGNOSIS > [WITH INTELLIGENT KEY SYSTEM] C D E F G H I J L M A B SEC N O P B2601 SHIFT POSITION Description INFOID:0000000009950137 BCM confirms the shift position with the following 4 signals. DTC Logic INFOID:0000000009950138 DTC DETECTION LOGIC NOTE: • If DTC B2601 is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to • If DTC B2601 is displayed with DTC B2603, first perform the trouble diagnosis for DTC B2603. Refer to DTC CONFIRMATION PROCEDURE 1. PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON under the following conditions and wait 2 seconds or more. - Selector lever is in the P or N position - Do not depress brake pedal 2. Check “Self-diagnosis result” using CONSULT. Is DTC detected? YES >> Go to NO >> INSPECTION END Diagnosis Procedure INFOID:0000000009950139 1. CHECK CVT SHIFT SELECTOR POWER SUPPLY 1. Turn ignition switch OFF. 2. Disconnect CVT shift selector (detention switch) connector. 3. Check voltage between CVT shift selector (detention switch) harness connector and ground. Is the inspection result normal? YES >> GO TO 3. NO >> GO TO 2. 2. CHECK CVT SHIFT SELECTOR POWER SUPPLY CIRCUIT DTC No. Trouble diagnosis name DTC detecting condition Possible cause B2601 SHIFT POSITION When there is a difference between P range signal • Harness or connectors (CVT shift selector circuit is open • CVT shift selector (detention switch) • BCM between BCM and IPDM E/R (+) (–) Voltage (V) (Approx.) CVT shift selector (detention switch) Connector Terminal M58 7 Ground 12 |