|
|
HAC-110 < ECU DIAGNOSIS INFORMATION > [AUTOMATIC AIR CONDITIONING] BCM (BODY CONTROL MODULE) REAR WIPER MOTOR PROTECTION BCM detects the rear wiper stopping position according to the rear wiper stop position signal. Condition of cancellation 1. More than 1 minute is passed after the rear wiper stop. 2. Turn rear wiper switch OFF. 3. Operate the rear wiper switch or rear washer switch. FAIL-SAFE CONTROL OF COMBINATION SWITCH READING FUNCTION CAUSED BY LOW If voltage of battery power supply lower, BCM maintains combination switch reading to the status when input BCM (BODY CONTROL SYSTEM) (WITH INTELLIGENT KEY SYSTEM) : INFOID:0000000010269341 If some DTCs are displayed at the same time, perform inspections one by one based on the following priority Display contents of CONSULT Fail-safe Cancellation B2192: ID DISCORD BCM-ECM Inhibit engine cranking Erase DTC B2193: CHAIN OF BCM-ECM Inhibit engine cranking Erase DTC B2195: ANTI-SCANNING Inhibit engine cranking Ignition switch ON → OFF B2198: NATS ANTENNA AMP Inhibit engine cranking Erase DTC B2608: STARTER RELAY Inhibit engine cranking 500 ms after the following signal communication status becomes con- B260F: ENG STATE SIG LOST Inhibit engine cranking When any of the following conditions are fulfilled B26F1: IGN RELAY OFF Inhibit engine cranking When the following conditions are fulfilled B26F2: IGN RELAY ON Inhibit engine cranking When the following conditions are fulfilled B26F3: START CONT RLY ON Inhibit engine cranking When the following conditions are fulfilled B26F4: START CONT RLY OFF Inhibit engine cranking When the following conditions are fulfilled B26F7: BCM Inhibit engine cranking When room antenna and luggage room antenna functions normally Priority DTC 1 B2562: LOW VOLTAGE 2 • U1000: CAN COMM CIRCUIT |