|
|
EXL-58 < DTC/CIRCUIT DIAGNOSIS > TAIL LAMP CIRCUIT TAIL LAMP CIRCUIT Component Function Check INFOID:0000000009945161 NOTE: 1. CHECK TAIL LAMP OPERATION IPDM E/R AUTO ACTIVE TEST 1. Start IPDM E/R auto active test. Refer to PCS-10, "Diagnosis Description" (without Intelligent Key). 2. Check that the tail lamp is turned ON. CONSULT ACTIVE TEST 1. Select “EXTERNAL LAMPS” of IPDM E/R active test item. 2. With operating the test items, check that the tail lamp is turned ON. Is the tail lamp turned ON? YES >> Tail lamp circuit is normal. NO >> Refer to . Diagnosis Procedure INFOID:0000000009945162 1. CHECK TAIL LAMP OUTPUT VOLTAGE CONSULT ACTIVE TEST 1. Disconnect the rear combination lamp connector. 2. Turn the ignition switch ON. 3. Select “EXTERNAL LAMPS” of IPDM E/R active test item. 4. With operating the test items, check the voltage between the IPDM E/R harness connector and the Is the measurement value normal? YES >> GO TO 2. NO >> Replace IPDM E/R. 2. CHECK TAIL LAMP OPEN CIRCUIT 1. Turn the ignition switch OFF. 2. Disconnect IPDM E/R connector. 3. Check continuity between the IPDM E/R harness connector and the rear combination lamp harness con- TAIL : Tail lamp ON Off : Tail lamp OFF Terminals Test item Voltage (Approx.) (+) ( − ) IPDM E/R Ground EXTERNAL LAMPS Connector Terminal RH E14 38 TAIL Battery volt- age Off 0 V LH 41 TAIL Battery volt- age Off 0 V |