Nissan Rogue. Manual - part 274
DAS
U1A39-00 COMBINATION METER COMMUNICATION
DAS-267
< DTC/CIRCUIT DIAGNOSIS >
[CHASSIS CONTROL]
C
D
E
F
G
H
I
J
K
L
M
B
N
P
A
U1A39-00 COMBINATION METER COMMUNICATION
DTC Description
INFOID:0000000011277438
DTC DETECTION LOGIC
POSSIBLE CAUSE
• Combination meter
• Chassis control module
• CAN communication line
DTC CONFIRMATION PROCEDURE
1.
PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn the ignition switch OFF
and wait at least 10 seconds before conducting the next test.
>> GO TO 2.
2.
CHECK DTC DETECTION
With CONSULT
1. Turn the ignition switch OFF to ON.
CAUTION:
Be sure to wait of 10 seconds after turning ignition switch OFF or ON.
2. Perform “Self Diagnostic Result” of “CHASSIS CONTROL”.
Is DTC “U1A39-00” detected?
YES
>> Proceed to
DAS-267, "Diagnosis Procedure"
NO-1 >> To check malfunction symptom before repair: Refer to
GI-44, "Intermittent Incident"
NO-2 >> Confirmation after repair: Inspection End.
Diagnosis Procedure
INFOID:0000000011277439
Regarding Wiring Diagram information, refer to
1.
CHECK CAN DIAGNOSIS SUPPORT MONITOR
With CONSULT
1. Select “CAN Diagnosis Support Monitor” of “CHASSIS CONTROL”.
2. Check malfunction between each control unit connected to chassis control module.
Check the result of “PRESENT”?
>> Refer to
LAN-9, "CAN Communication Control Circuit"
.
“TRANSMIT DIAG” is other than “OK”>>GO TO 2.
“METER/M&A” other than “OK”>>GO TO 3.
2.
CHECK TRANSMITTING SIDE UNIT
1. Turn the ignition switch OFF.
2. Disconnect chassis control module harness connector.
3. Check the chassis control module harness connector terminals No. 3 and 4 for damage or loose connec-
tion.
Is the inspection result normal?
YES
>> GO TO 5.
DTC
Display Item
(Trouble diagnosis content)
Malfunction detected condition
U1A39-00
COMBINATION METER COMM
(Combination meter communica-
tion)
When chassis control module is not receiving CAN communication signal (be-
tween chassis control module and combination meter) for 2 seconds or more.