|
|
Content .. 1259 1260 1261 1262 ..
REAR WIPER AUTO STOP SIGNAL CIRCUIT WW-47 < DTC/CIRCUIT DIAGNOSIS > C D E F G H I J K M A B WW N O P REAR WIPER AUTO STOP SIGNAL CIRCUIT Component Function Check INFOID:0000000011280404 1. CHECK REAR WIPER (AUTO STOP) OPERATION CONSULT DATA MONITOR 1. Select “WIPER” in “Data Monitor” of “BCM”. 2. Operate the rear wiper. 3. Check that RR WIPER STOP changes to ON and OFF linked with the wiper operation. Is the inspection result normal? YES >> Rear wiper auto stop signal circuit is normal. NO >> Refer to . Diagnosis Procedure INFOID:0000000011280405 Regarding Wiring Diagram information, refer to . 1. CHECK REAR WIPER MOTOR AUTO STOP CIRCUITS FOR OPEN 1. Turn ignition switch OFF. 2. Disconnect BCM and rear wiper motor. 3. Check continuity between BCM harness connector terminal and rear wiper motor harness connector ter- minal. Is inspection result normal? YES >> GO TO 2. NO >> Repair or replace harness. 2. CHECK AUTO STOP CIRCUITS FOR SHORT TO GROUND Check continuity between BCM harness connector terminal and ground. Is inspection result normal? YES >> Replace BCM. Refer to BCS-75, "Removal and Installation" (with Intelligent Key system) or 135, "Removal and Installation" (with Intelligent Key system). NO >> Repair or replace harness. Monitor item Condition Monitor status RR WIPER STOP Rear wiper motor Stop position ON Except stop position OFF BCM Rear wiper motor Continuity Connector Terminal Connector Terminal B16 55 D506 2 Yes BCM Ground Continuity Connector Terminal B16 55 No |