|
|
Content .. 1100 1101 1102 1103 ..
B27D2 START CUT RELAY ON SEC-187 < DTC/CIRCUIT DIAGNOSIS > [WITHOUT INTELLIGENT KEY SYSTEM] C D E F G H I J L M A B SEC N O P Is the inspection result normal? YES >> GO TO 4. NO >> GO TO 3. 3. CHECK STARTER CUT RELAY CONTROL CIRCUIT 1. Turn ignition switch OFF. 2. Disconnect BCM connector. 3. Disconnect starter cut relay. 4. Check continuity between BCM harness connector and starter cut relay harness connector. Is the inspection result normal? YES >> GO TO 4. NO >> Repair or replace harness. 4. CHECK STARTER CUT RELAY CIRCUIT 1. Turn ignition switch OFF. 2. Disconnect IPDM E/R connector. 3. Check continuity between IPDM E/R harness connector and starter cut relay harness connector. 4. Check continuity between BCM harness connector and ground. Is the inspection result normal? YES >> GO TO 5. NO >> Repair or replace harness. 5. CHECK STARTER CUT RELAY SEC-188, "Component Inspection" . Is the inspection result normal? YES >> GO TO 6. NO >> Replace starter cut relay. 6. REPLACE BCM 1. Replace BCM. Refer to BCS-135, "Removal and Installation" . 2. Perform initialization of BCM and registration of all keys using CONSULT. 3. Perform DTC CONFIRMATION PROCEDURE for DTC B27D2. Refer to Is the inspection result normal? YES >> Inspection End. NO >> Replace IPDM E/R. Refer to PCS-40, "Removal and Installation" . (+) (–) Condition Voltage (V) (Approx.) BCM Connector Terminal E29 139 Ground CVT shift selector lever N or P position Battery voltage Other than above 0 BCM Starter cut relay Continuity Connector Terminal Connector Terminal E29 139 F55 2 Yes IPDM E/R Starter cut relay Continuity Connector Terminal Connector Terminal F41 86 F55 5 Yes IPDM E/R Ground Continuity Connector Terminal F41 86 No 2015 Rogue NAM |