|
|
PG-2 < BASIC INSPECTION > BATTERY BASIC INSPECTION BATTERY How to Handle Battery INFOID:0000000009465137 CAUTION: • If it becomes necessary to start the engine with a booster battery and jumper cables, use a 12-volt booster battery. • After connecting battery cables, ensure that they are tightly clamped to battery terminals for good contact. • Never add distilled water through the hole used to check specific gravity. METHODS OF PREVENTING OVER-DISCHARGE The following precautions must be taken to prevent over-discharging a battery. • The battery surface (particularly its top) should always be kept clean and dry. • The terminal connections should be clean and tight. • At every routine maintenance, check the electrolyte level. This also applies to batteries designated as “low maintenance” and “maintenance-free”. • When the vehicle is not going to be used over a long period of time, disconnect the battery cable from the negative terminal. (If the vehicle has an extended storage switch, turn it off.) Work Flow INFOID:0000000009465138 BATTERY DIAGNOSIS WITH EXP-800 NI OR GR8-1200 NI To diagnose and confirm the condition of the battery, use the following special service tools: • EXP-800 NI Battery and electrical diagnostic analyzer • GR8-1200 NI Multitasking battery and electrical diagnostic station NOTE: Refer to the applicable Instruction Manual for proper battery diagnosis procedures. BATTERY DIAGNOSIS WITHOUT EXP-800 NI OR GR8-1200 NI Checking Electrolyte Level WARNING: Never allow battery fluid to come in contact with skin, eyes, fabrics, or painted surfaces. After touch- ing a battery, never touch or rub your eyes until you have thoroughly washed your hands. If acid con- tacts eyes, skin or clothing, immediately flush with water for 15 minutes and seek medical attention. Failure to do this may cause personal injury or damage to clothing or the painted surfaces. MEL040F ELA0349D |