Nissan Altima HL32 Hybrid. Manual - part 756

 

  Index      Nissan     Nissan Altima HL32 Hybrid (2009 year) - Service and Repair Manual

 

Search            

 

 

 

 

 

 

 

 

 

Content   ..  754  755  756  757   ..

 

 

Nissan Altima HL32 Hybrid. Manual - part 756

 

 

HEADLINING

INT-23

< ON-VEHICLE REPAIR >

C

D

E

F

G

H

I

K

L

M

A

B

INT

N

O

P

HEADLINING

Exploded View

INFOID:0000000004215431

Removal and Installation

INFOID:0000000004215432

CAUTION:

• Disconnect the 12-volt negative and positive battery terminals.

• Be careful not to bend headlining during removal or installation.

REMOVAL

1.

Map lamp assembly

2.

Mirror harness cover

3.

Sunvisor holder

4.

Sunvisor

5.

Sunvisor cover

6.

Headlining assembly (without sunroof)

7.

Headlining assembly (with 
sunroof)

8.

Rear assist grip

9.

Front assist grip

10. Sunroof clip

A.

Metal clip

B.

Dual lock fastener

C.

Clip C101

Vehicle front

ALJIA0006ZZ

INT-24

< ON-VEHICLE REPAIR >

HEADLINING

1. Place gear selector lever to D position, then recline the front seats to the fully reclined position.
2. Disconnect the 12-volt battery negative and positive terminals.
3. Remove front pillar finisher (RH/LH). Refer to 

INT-16, "Removal and Installation"

.

4. Disconnect headlining harness and antenna feeder connectors.
5. Remove center pillar upper and rear pillar finishers. Refer to 

INT-16, "Removal and Installation"

.

6. Disconnect antenna amplifier and rear window defogger connectors. 
7. Release the molded clip, then remove front and rear assist

grips.

8. Remove the sunvisor covers and screws, and then remove sunvisors (RH/LH).

•  If equipped, disconnect vanity mirror illumination harness connector.

9. Insert a suitable thin tool into the sunvisor holder notch and

press in to release the locking tab.

• Rotate sunvisor holder 90 degrees and pull away from head-

lining to remove.

10. Remove map lamp assembly.

• For sunroof equipped vehicles: Release the pawls and lower map lamp assembly away from headliner.

Disconnect the map lamp and sunroof switch connectors, then remove the map lamp assembly.

• For non-sunroof equipped vehicles: The map lamp assembly is an integral part of the headlining, and

repaired only as an assembly.

11. For sunroof equipped vehicles, use a suitable tool to release dual lock fastener(s) around the sunroof

opening and release the sunroof clip. 

12. Release the three hidden clips near the rear edge of headliner using a suitable clip removal tool.
13. Drop headlining down and carefully rotate into position. Remove

headlining through rear door opening.

CAUTION:

• When removing, two workers are required. (one for each

front and rear of headlining)

• Cover center console finisher upper surface with a shop

cloth to prevent damage.

14. The following components are integral to the headliner and are repaired only as an assembly:

• Personal lamp (LH/RH). 

• Roof harness assembly.

• Antenna feeder assembly.

INSTALLATION

PIIB3585J

SIIA0224J

PIIB4940E

HEADLINING

INT-25

< ON-VEHICLE REPAIR >

C

D

E

F

G

H

I

K

L

M

A

B

INT

N

O

P

Installation is in the reverse order of removal.

INT-26

< ON-VEHICLE REPAIR >

TRUNK ROOM TRIM & TRUNK LID FINISHER

TRUNK ROOM TRIM & TRUNK LID FINISHER

Exploded View

INFOID:0000000004215433

TRUNK ROOM TRIM

ALJIA0008ZZ

 

 

 

 

 

 

 

Content   ..  754  755  756  757   ..