|
|
BRC-200 < DTC/CIRCUIT DIAGNOSIS > [TYPE 2] ABS WARNING LAMP ABS WARNING LAMP Description INFOID:0000000009479515 ×: ON –: OFF Component Function Check INFOID:0000000009479516 1. CHECK ABS WARNING LAMP OPERATION Check that the lamp illuminates for approximately 2 seconds after the ignition switch is turned ON. YES >> Inspection End NO >> Go to diagnosis procedure. Refer to BRC-200, "Diagnosis Procedure" Diagnosis Procedure INFOID:0000000009479517 1. CHECK SELF-DIAGNOSIS Perform ABS actuator and electric unit (control unit) self-diagnosis. Refer to Is the inspection result normal? YES >> GO TO 2 NO >> Check items displayed by self-diagnosis. 2. CHECK COMBINATION METER Check if the indication and operation of combination meter are normal. Refer to . Is the inspection result normal? YES >> Replace ABS actuator and electric unit (control unit). Refer to BRC-236, "Removal and Installa- . NO >> Replace combination meter. Refer to MWI-90, "Removal and Installation" Special Repair Requirement INFOID:0000000009479518 1. ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL POSITION Always perform neutral position adjustment for the steering angle sensor when replacing the ABS actuator and electric unit (control unit). Refer to BRC-124, "ADJUSTMENT OF STEERING ANGLE SENSOR NEU- >> GO TO 2 2. CALIBRATION OF DECEL G SENSOR Always perform calibration of decel G sensor when replacing the ABS actuator and electric unit (control unit). BRC-125, "CALIBRATION OF DECEL G SENSOR : Description" . >> END Condition ABS warning lamp Ignition switch OFF – For 2 seconds after turning ON ignition switch × 2 seconds later after turning ON ignition switch – ABS function is malfunctioning. × EBD function is malfunctioning. × |