|
|
TM-196 < DTC/CIRCUIT DIAGNOSIS > [CVT: RE0F11A] P0848 TRANSMISSION FLUID PRESSURE SEN/SW B P0848 TRANSMISSION FLUID PRESSURE SEN/SW B DTC Logic INFOID:0000000009759436 DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1. PREPARATION BEFORE WORK If another “DTC CONFIRMATION PROCEDURE” occurs just before, the ignition switch OFF and wait for at least 10 seconds, then perform the next test. >> GO TO 2. 2. CHECK DTC DETECTION With CONSULT 1. Start the engine. 2. Select “Data Monitor” in “TRANSMISSION”. 3. Select “FLUID TEMP”. 4. Maintain the following conditions for 10 seconds or more. 5. Check the first trip DTC. With GST 1. Start the engine and wait for at least 10 seconds. CAUTION: When the ambient temperature is −20°C (−4°F) or less and the engine is cold, warm up the engine for approximately 5 minutes. 2. Check the first trip DTC. YES >> Go to NO >> INSPECTION END Diagnosis Procedure INFOID:0000000009759437 1. CHECK SECONDARY PRESSURE SENSOR POWER SUPPLY CIRCUIT 1. Turn ignition switch OFF. 2. Disconnect CVT unit connector. 3. Turn ignition switch ON. 4. Check voltage between CVT unit harness connector terminal and ground. DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition Possible causes P0848 TRANSMISSION FLUID The secondary pressure sensor voltage is 4.7 −20°C (− 4 °F) - Secondary pressure target value: 5.7 MPa or less - TCM power supply voltage: More than 11 V • Harness or connector (Secondary pressure sensor circuit is • Secondary pressure sensor FLUID TEMP : −19°C (−2.2°F) or more + - Voltage (Approx.) TCM Connector Terminal F46 16 Ground 5.0 V |