|
|
RF-18 < BASIC INSPECTION > INSPECTION AND ADJUSTMENT INSPECTION AND ADJUSTMENT ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT INFOID:0000000009756131 MEMORY RESET PROCEDURE 1. Please observe the following instructions at confirming the moonroof operation. NOTE: Do not disconnect the electronic power while the moonroof is operating or within 5 seconds after the moonroof stops. (to wipe-out the memory of lid position and operating friction.) 2. Initialization of system should be conducted after the following conditions. • When the moonroof motor is changed. • When the moonroof does not operate normally. (Incomplete initialization conditions) ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Re- INFOID:0000000009756132 INITIALIZATION PROCEDURE If the moonroof does not open or close automatically, use the following procedure to return moonroof opera- tion to normal. NOTE: If the moonroof switch is released at any time during step 4, the procedure must be started over again. Leave the ignition switch ON for at least 2 seconds after this procedure. 1. Push the ignition switch to the ON position. 2. Hold the moonroof switch in the close/tilt up position. Release the switch when the moonroof has reached the full tilt up position and reverses slightly. 3. Push and hold the tilt up switch within 4 seconds of step 2. 4. The moonroof will begin moving within 4 seconds. From the full tilt-up → slide-close → slide-open → slide-close → tilt-up → slide-close. Release the switch, initialization is complete if the moonroof operates normally. ANTI-PINCH FUNCTION 1. Fully open the moonroof to the full open position. 2. Place a piece of wood at the fully closed position. 3. Close the moonroof completely with auto-slide close function. 4. Moonroof should make contact and then tilt up in reverse for 150mm (5.91 in.) (approx.). CAUTION: • Do not test the anti-pinch function with your hands or other part of body parts because they may be pinched. • Depending on environment and driving conditions, if a similar impact or load is applied to the moon- roof it may lower. • Test the auto-slide operation before inspection when the system initialization is performed. • Perform the initialization procedure when the auto-slide operation or anti-pinch function does not operate normally. |