|
|
DOOR LOCK AND UNLOCK SWITCH DLK-95 < DTC/CIRCUIT DIAGNOSIS > C D E F G H I J L M A B DLK N O P DOOR LOCK AND UNLOCK SWITCH DRIVER SIDE INFOID:0000000010119774 1. CHECK FUNCTION 1. Select “DOOR LOCK” of “BCM” using CONSULT. 2. Select “CDL LOCK SW”, “CDL UNLOCK SW” in “Data Monitor”. 3. Check that the function operates normally according to the following conditions: Is the inspection result normal? YES >> Door lock and unlock switch is OK. NO >> Refer to DLK-95, "DRIVER SIDE : Diagnosis Procedure" DRIVER SIDE : Diagnosis Procedure INFOID:0000000010119775 Regarding Wiring Diagram information, refer to . 1. CHECK DOOR LOCK AND UNLOCK SWITCH INPUT SIGNAL 1. Turn power switch OFF. 2. Disconnect main power window and door lock/unlock switch connector. 3. Check signal between main power window and door lock/unlock switch harness connector and ground using oscilloscope. Is the inspection result normal? YES >> GO TO 3. NO >> GO TO 2. 2. CHECK DOOR LOCK AND UNLOCK SWITCH CIRCUIT 1. Disconnect BCM connector and power window and door lock/unlock switch RH connector. 2. Check continuity between BCM harness connector and main power window and door lock/unlock switch harness connector. Monitor item Condition Status CDL LOCK SW Door lock and unlock switch Lock ON Unlock OFF CDL UNLOCK SW Lock OFF Unlock ON (+) (–) Signal (Reference value) Main power window and door lock/unlock switch Connector Terminal D35 3 Ground 1.0 - 1.5 V 15 JPMIA0012GB |