|
|
BCS-58 < BASIC INSPECTION > INSPECTION AND ADJUSTMENT CONFIGURATION (BCM) : Description INFOID:0000000010122333 Vehicle specification needs to be written with CONSULT because it is not written after replacing BCM. Configuration has three functions as follows: CAUTION: • When replacing BCM, you must perform “Select Saved Data List” or "After Replace ECU" with CON- SULT. • Complete the procedure of “Select Saved Data List” or "After Replace ECU" in order. • If you set incorrect “Select Saved Data List” or "After Replace ECU", incidents might occur. • Configuration is different for each vehicle model. Confirm configuration of each vehicle model. • Never perform “Select Saved Data List” or "After Replace ECU" except for new BCM. CONFIGURATION (BCM) : Work Procedure INFOID:0000000010122334 1. WRITING MODE SELECTION CONSULT Select “Reprogramming, Configuration” of BCM. When writing saved data>>GO TO 2. When writing manually>>GO TO 3. 2. PERFORM “SAVED DATA LIST” CONSULT Automatically “Operation Log Selection” window will display if “Before Replace ECU” was performed. Select applicable file from the “Save Data List” and press “Confirm”. >> Work End. 3. PERFORM “AFTER REPLACE ECU” OR “MANUAL CONFIGURATION” CONSULT 1. Select “After Replace ECU” or “Manual Configuration”. 2. Identify the correct model and configuration list. Refer to BCS-59, "CONFIGURATION (BCM) : Configura- . 3. Confirm and/or change setting value for each item. CAUTION: Thoroughly read and understand the vehicle specification. ECU control may not operate normally if the setting is not correct. 4. Select “Next”. CAUTION: Make sure to select “Next”, confirm each setting value and press “OK” even if the indicated con- figuration of brand new BCM is same as the desirable configuration. If not, configuration which is set automatically by selecting vehicle model cannot be memorized. 5. When "Completed", select "End". >> GO TO 4. 4. OPERATION CHECK Confirm that each function controlled by BCM operates normally. >> Work End. Function Description "Before Replace ECU" • Reads the vehicle configuration of current BCM. "After Replace ECU" Writes the vehicle configuration with manual selection. "Select Saved Data List" Writes the vehicle configuration with saved data. |