Nissan March K13. Manual - part 16
BCS
BCM
BCS-37
< ECU DIAGNOSIS INFORMATION >
[WITH INTELLIGENT KEY SYSTEM]
C
D
E
F
G
H
I
J
K
L
B
A
O
P
N
Fail-safe
INFOID:0000000006014842
FAIL-SAFE CONTROL BY DTC
BCM performs fail-safe control when any DTC are detected.
100
(L)
Ground
Push-button ignition
switch (push switch)
Input
Push-button ig-
nition switch
(push switch)
Pressed
0 V
Not pressed
12 V
102
(BR)
Ground
Selector lever P/N
position
Input
Selector lever
P or N position
Battery voltage
Except P and N posi-
tions
0 V
104
(P)
Ground
A/T shift selector
(detention switch)
power supply
Output
Ignition switch ON
12 V
105
(SB)
Ground
Stop lamp switch 2
Input
Ignition switch OFF
Battery voltage
106
(Y)
Ground
Blower relay control
Output
Ignition switch
OFF or ACC
0 V
ON
12 V
107
(GR)
Ground
Steering lock condi-
tion No. 1
Input
Steering lock
LOCK status
0 V
UNLOCK status
12 V
108
(P)
Ground
Steering lock condi-
tion No. 2
Input
Steering lock
LOCK status
12 V
UNLOCK status
0 V
Terminal No.
(Wire color)
Description
Condition
Value
(Approx.)
Signal name
Input/
Output
+
−
Display contents of CONSULT
Fail-safe
Cancellation
B2013: ID DISCORD BCM-S/L
Inhibit engine cranking
When communication between BCM and steering lock unit are commu-
nicated normally.
B2014: CHAIN OF S/L-BCM
Inhibit engine cranking
When communication between BCM and steering lock unit are commu-
nicated normally.
B2192: ID DISCORD BCM-ECM
Inhibit engine cranking
Erase DTC
B2193: CHAIN OF BCM-ECM
Inhibit engine cranking
Erase DTC
B2195: ANTI-SCANNING
Inhibit engine cranking
Ignition switch ON
→
OFF
B2198: NATS ANTENNA AMP
Inhibit engine cranking
Erase DTC
B2557: VEHICLE SPEED
Inhibit steering lock
When the following CAN signal status (vehicle speed signal) becomes
consistent
• Vehicle speed signal (ABS)
• Vehicle speed signal (Meter)
B2601: SHIFT POSITION
Inhibit steering lock
500 ms after the following signal reception status becomes consistent
• Selector lever P position switch signal
• P range signal (CAN)
B2602: SHIFT POSITION
Inhibit steering lock
5 seconds after the following BCM recognition conditions are fulfilled
• Ignition switch is in the ON position
• Selector lever P position switch signal: Except P position (12 V)
• Vehicle speed: 4 km/h (2.5 MPH) or more
B2603: SHIFT POSI STATUS
Inhibit steering lock
500 ms after any of the following BCM recognition conditions are fulfilled
• Status 1
- Ignition switch is in the ON position
- Selector lever P position switch signal: Except P position (12 V)
- Selector lever P/N position signal: Except P and N positions (0 V)
• Status 2
- Ignition switch is in the ON position
- Selector lever P position switch signal: P position (0 V)
- Selector lever P/N position signal: P or N positions (12 V)