Nissan Almera Tino V10. Manual - part 91
AT-88
[EURO-OBD]
TROUBLE DIAGNOSIS — GENERAL DESCRIPTION
Sharp shock in shifting from “N” to
“D” position.
ON vehicle
1. Engine idling rpm
EC-48, "Idle Speed and
Ignition Timing Check"
(With EURO-OBD),
575, "Idle Speed and Igni-
tion Timing Check"
(With-
out EURO-OBD)
2. Throttle position sensor [Accelerator
pedal position (APP) sensor]
AT-183, "DTC P1705
ACCELERATOR PEDAL
POSITION (APP) SEN-
SOR"
3. Line pressure test
4. A/T fluid temp sen circ and TCM pow sour
AT-197, "DTC BATT/FLUID
TEMP SEN (A/T FLUID
TEMP SENSOR CIRCUIT
AND TCM POWER
SOURCE)"
5. Engine speed signal
AT-131, "DTC P0725
ENGINE SPEED SIGNAL"
6. Line pressure solenoid valve
AT-166, "DTC P0745 LINE
PRESSURE SOLENOID
VALVE"
7. Control valve assembly
AT-410, "Control Valve
Assembly and Accumula-
tors"
8. Accumulator N-D
AT-410, "Control Valve
Assembly and Accumula-
tors"
OFF vehicle
9. Forward clutch
AT-468, "Forward and
Overrun Clutches"
Vehicle will not run in “D” and “2”
positions (but runs in “1” and “R”
positions).
ON vehicle
1. Control cable adjustment
AT-412, "Control Cable
Adjustment"
OFF vehicle
2. Low one-way clutch
421, "Locations of Adjust-
ing Shims, Needle Bear-
ings, Thrust Washers and
Snap Rings"
Vehicle will not run in “D”, “1”, “2”
positions (but runs in “R” position).
Clutch slips. Very poor acceleration.
AT-221, "7. Vehicle Does Not Creep
Forward In “D”, “2” Or “1” Position"
ON vehicle
1. Fluid level
2. Line pressure test
3. Line pressure solenoid valve
AT-166, "DTC P0745 LINE
PRESSURE SOLENOID
VALVE"
4. Control valve assembly
AT-410, "Control Valve
Assembly and Accumula-
tors"
5. Accumulator N-D
AT-410, "Control Valve
Assembly and Accumula-
tors"
Symptom
Condition
Diagnostic Item
Reference Page
EURO-OBD