|
|
EXL-162 < ECU DIAGNOSIS > [XENON TYPE] AUTO LEVELIZER CONTROL UNIT DTC Inspection Priority Chart INFOID:0000000003805625 If some DTCs are displayed at the same time, perform inspections one by one based on the following priority B2082: SENSOR OUT OF After engine start Fix with the light axis facing When sensor signal returns to While driving Maintain the light axis at the B2083: SEN SIG NOT PLAU- • Maintain the aiming motor drive signal output at the time of DTC detection • Maintain the light axis at the time of DTC detection Ignition switch OFF B2084: VOLTAGE UNDER After engine start Fix with the light axis facing Ignition switch OFF While driving Maintain the light axis at the B2085: LOWBEAM SIG After engine start Fix with the light axis facing Ignition switch OFF While driving Maintain the light axis at the B2086: FRQ. OVER LIMIT After engine start Fix with the light axis facing Ignition switch OFF While driving Maintain the light axis at the B2087: SHORT TO GROUND Maintain the light axis at the time of DTC detection Ignition switch OFF B2088: SHORT TO BATTERY Maintain the light axis at the time of DTC detection Ignition switch OFF B208A: PARA NOT PROG Fix aiming motor drive signal output to approximately 0 V Write configuration is complet- DTC Fail-safe Cancellation Priority DTC 1 • B2080: ECU TROUBLE |