Nissan Teana J32. Manual - part 1173

TM-216

< COMPONENT DIAGNOSIS >

[CVT: RE0F10A]

P0710 CVT FLUID TEMPERATURE SENSOR

P0710 CVT FLUID TEMPERATURE SENSOR

Description

INFOID:0000000003806390

The CVT fluid temperature sensor detects the CVT fluid temperature and sends the signal to the TCM.

DTC Logic

INFOID:0000000003806391

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE

CAUTION:

Always drive vehicle at a safe speed.
NOTE:
If “DTC CONFIRMATION PROCEDURE” has been previously performed, always turn ignition switch
OFF. Then wait at least 10 seconds before performing the next test.
Perform the following procedure to confirm the malfunction is eliminated after the repair.

1.

CHECK DTC DETECTION

With CONSULT-III

1.

Turn ignition switch ON.

2.

Select “Data Monitor” mode for “TRANSMISSION”.

3.

Start engine and maintain the following conditions for at least 10 minutes (total).

With GST

Follow the procedure “With CONSULT-III”.
Is “P0710 ATF TEMP SEN/CIRC” detected?

YES

>> Go to 

TM-216, "Diagnosis Procedure"

.

NO

>> Check intermittent incident. Refer to 

GI-35, "Intermittent Incident"

.

Diagnosis Procedure

INFOID:0000000003806392

1.

 CHECK CVT FLUID TEMPERATURE SENSOR CIRCUIT

1.

Turn ignition switch OFF.

2.

Disconnect the TCM connector.

3.

Check resistance between TCM vehicle side harness connector terminals.

Is the inspection result normal?

YES

>> GO TO 5.

NO

>> GO TO 2.

2.

 CHECK HARNESS BETWEEN TCM AND CVT UNIT (CVT FLUID TEMPERATURE SENSOR) (PART 1)

DTC

Item

(CONSULT-III screen term)

Malfunction is detected when...

Possible cause

P0710

ATF TEMP SEN/CIRC

During running, the CVT fluid 
temperature sensor signal volt-
age is excessively high or low.

• Harness or connectors

(Sensor circuit is open or 
shorted.)

• CVT fluid temperature sensor

VEHICLE SPEED

: 10 km/h (6 MPH) or more

ENG SPEED

: 450 rpm more than

ACC PEDAL OPEN

: More than 1.0/8

RANGE

: “D” position

TCM vehicle side harness connector

Condition

Resistance (Approx.)

Connector

Terminal

F23

13

 25

When CVT fluid temperature is 20

°

C (68

°

F)

6.5 k

Ω

When CVT fluid temperature is 80

°

C (176

°

F)

0.9 k

Ω

P0710 CVT FLUID TEMPERATURE SENSOR

TM-217

< COMPONENT DIAGNOSIS >

[CVT: RE0F10A]

C

E

F

G

H

I

J

K

L

M

A

B

TM

N

O

P

1.

Disconnect CVT unit connector.

2.

Check continuity between TCM vehicle side harness connector terminals and CVT unit vehicle side har-
ness connector terminals.

Is the inspection result normal?

YES

>> GO TO 3.

NO

>> Repair or replace damaged parts.

3.

 CHECK HARNESS BETWEEN TCM AND CVT UNIT (CVT FLUID TEMPERATURE SENSOR) (PART 2)

Check continuity between TCM vehicle side harness connector terminals and ground.

Is the inspection result normal?

YES

>> GO TO 4.

NO

>> Repair or replace damaged parts.

4.

 CHECK CVT FLUID TEMPERATURE SENSOR

Check CVT fluid temperature sensor. Refer to 

TM-217, "Component Inspection (CVT Fluid Temperature Sen-

sor)"

.

Is the inspection result normal?

YES

>> GO TO 5.

NO

>> Repair or replace damaged parts.

5.

CHECK TCM

Check TCM connector pin terminals for damage or loose connection with harness connector.

Is the inspection result normal?

YES

>> Replace the TCM. Refer to 

TM-315, "Exploded View"

.

NO

>> Repair or replace damaged parts.

Component Inspection (CVT Fluid Temperature Sensor)

INFOID:0000000003806393

1.

CHECK CVT FLUID TEMPERATURE SENSOR

Check resistance between CVT unit harness connector terminals.

Is the inspection result normal?

YES

>> INSPECTION END

NO

>> Replace the transaxle assembly. Refer to 

TM-332, "Exploded View"

.

TCM vehicle side harness connector

CVT unit vehicle side harness connector

Continuity

Connector

Terminal

Connector

Terminal

F23

13

F24

17

Existed

25

19

TCM vehicle side harness connector

Ground

Continuity

Connector

Terminal

F23

13

Not existed

25

CVT unit harness connector

Condition

Resistance (Approx.)

Connector

Terminal

 F24

 17

 19

When CVT fluid temperature is 20

°

C (68

°

F)

6.5 k

Ω

When CVT fluid temperature is 80

°

C (176

°

F)

0.9 k

Ω

TM-218

< COMPONENT DIAGNOSIS >

[CVT: RE0F10A]

P0715 INPUT SPEED SENSOR (PRI SPEED SENSOR)

P0715 INPUT SPEED SENSOR (PRI SPEED SENSOR)

Description

INFOID:0000000003806394

The input speed sensor (primary speed sensor) detects the primary pulley revolution speed and sends the sig-
nal to the TCM.

DTC Logic

INFOID:0000000003806395

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE

CAUTION:

Always drive vehicle at a safe speed.
NOTE:
If “DTC CONFIRMATION PROCEDURE” has been previously performed, always turn ignition switch
OFF. Then wait at least 10 seconds before performing the next test.
Perform the following procedure to confirm the malfunction is eliminated after the repair.

1.

CHECK DTC DETECTION

With CONSULT-III

1.

Turn ignition switch ON.

2.

Select “Data Monitor” mode for “TRANSMISSION”.

3.

Start engine and maintain the following conditions for at least 5 consecutive seconds.

With GST

Follow the procedure “With CONSULT-III”.

Is “P0715 INPUT SPD SEN/CIRC” detected?

YES

>> Go to 

TM-218, "Diagnosis Procedure"

.

NO

>> Check intermittent incident. Refer to 

GI-35, "Intermittent Incident"

.

Diagnosis Procedure

INFOID:0000000003806396

1.

CHECK INPUT SPEED SENSOR (PRIMARY SPEED SENSOR)

With CONSULT-III

1.

Start engine.

2.

Check voltage between TCM connector terminals.

DTC

Item

(CONSULT-III screen term)

Malfunction is detected when...

Possible cause

P0715

INPUT SPD SEN/CIRC

• Input speed sensor (primary 

speed sensor) signal is not in-
put due to an open circuit.

• An unexpected signal is input 

when vehicle is being driven.

• Harness or connectors

(Sensor circuit is open or 
shorted.)

• Input speed sensor (primary 

speed sensor)

VEHICLE SPEED

: 10 km/h (6 MPH) or more

ACC PEDAL OPEN

: More than 1.0/8

RANGE

: “D” position

ENG SPEED

: 450 rpm or more

Driving location

: Driving the vehicle uphill (increased engine load) will help maintain the 
driving conditions required for this test.

TCM connector

Voltage (Approx.)

Connector

Terminal

(+)

(

−

)

F23

46

25

Battery voltage

48

P0715 INPUT SPEED SENSOR (PRI SPEED SENSOR)

TM-219

< COMPONENT DIAGNOSIS >

[CVT: RE0F10A]

C

E

F

G

H

I

J

K

L

M

A

B

TM

N

O

P

3.

If OK, check pulse when vehicle cruises.

Is the inspection result normal?

YES

>> GO TO 12.

NO

>> GO TO 2.

2.

CHECK POWER AND SENSOR GROUND

1.

Turn ignition switch OFF.

2.

Disconnect input speed sensor (primary speed sensor) connector.

3.

Turn ignition switch ON.

4.

Check voltage between input speed sensor (primary speed sensor) vehicle side harness connector termi-
nals.

5.

Check voltage between input speed sensor (primary speed sensor) vehicle side harness connector termi-
nal and ground.

Is the inspection result normal?

YES

>> GO TO 3.

NO-1 (Battery voltage is not supplied between terminals 1 and 3, and between terminal 3 and ground)>>GO

TO 6.

NO-2 (Battery voltage is not supplied between terminals 1 and 3 only)>>GO TO 8.

3.

CHECK HARNESS BETWEEN TCM AND INPUT SPEED SENSOR (PRIMARY SPEED SENSOR) (SEN-

SOR GROUND)

1.

Turn ignition switch OFF.

2.

Disconnect TCM connector and CVT unit connector.

3.

Check continuity between TCM vehicle side harness connector terminal and ground.

Is the inspection result normal?

YES

>> GO TO 4.

NO

>> Repair or replace damaged parts.

4.

CHECK HARNESS BETWEEN TCM AND INPUT SPEED SENSOR (PRIMARY SPEED SENSOR) (PART

1)

Check continuity between TCM vehicle side harness connector terminal and input speed sensor (primary
speed sensor) vehicle side harness connector terminal.

TCM connector

Condition

Data (Approx.)

Connector

Terminal

F23

33

When driving at 20 km/h (12 
MPH) in “L” position, use the 
CONSULT-III pulse frequency 
measuring function.

950 Hz

Input speed sensor (primary speed sensor) vehicle side harness connector

Voltage (Approx.)

Connector

Terminal

(+)

(

−

)

F55

3

1

Battery voltage

Input speed sensor (primary speed sensor) vehicle side harness 

connector

Ground

Voltage (Approx.)

Connector

Terminal

F55

3

Battery voltage

TCM vehicle side harness connector

Ground

Continuity

Connector

Terminal

F23

25

Not existed