|
|
содержание .. 350 351 352 353 ..
WATER OUTLET AND WATER PIPING CO-29 < REMOVAL AND INSTALLATION > C D E F G H I J K L M A CO N P O 5. Remove CVT fluid charging pipe and CVT fluid level gauge. Refer to 6. Move CVT control cable aside. Refer to 7. Remove vacuum tube (front) mounting bolt from water outlet. Refer to (2WD models) or (AWD models). 8. Remove radiator hose (upper) from water outlet. 9. Remove water hoses and heater hoses. 10. Disconnect harness connectors, and move harness to aside. 11. Remove engine coolant temperature sensor if necessary. CAUTION: Be careful not to damage engine coolant temperature sensor. 12. Remove water outlet, heater pipe, water bypass pipe and water connector. INSTALLATION Note the following, and install in the reverse order of removal. Inspection INFOID:0000000005518111 INSPECTION AFTER INSTALLATION • Check for leakage of engine coolant using the radiator cap tester adapter (commercial service tool) and the radiator cap tester (commercial service tool). Refer to • Start and warm up the engine. Visually check that there is no leakage of engine coolant. |