|
|
содержание .. 1517 1518 1519 1520 ..
WT-14 < SYSTEM DESCRIPTION > DIAGNOSIS SYSTEM (BCM) Without CONSULT-III • In order to make it easier to find the cause of hard-to-duplicate malfunctions, malfunction information is stored into the control unit as necessary during use by the user. This memory is not erased no matter how • However, this information is erased by turning ignition switch OFF after performing self-diagnostic or by erasing the memory using the CONSULT-III. AIR PRESSURE MONITOR : CONSULT-III Function (BCM - AIR PRESSURE MONI- INFOID:0000000005514387 WORK SUPPORT MODE ID Read The registered ID number is displayed. ID Regist WT-22, "ID REGISTRATION PROCEDURE : Special Repair Requirement" . SELF-DIAG RESULTS MODE Operation Procedure DATA MONITOR MODE Screen of data monitor mode is displayed. Display item list NOTE: ACTIVE TEST MODE NOTE: TEST ITEM LIST Monitor Condition Specification AIR PRESS FL • Drive vehicle for a few minutes. or • Ignition switch ON and activation tool is trans- mitting activation signals. Tire pressure (kPa, kg/cm 2 or Psi) ID REGST FL Ignition switch ON Registration ID: Green WARNING LAMP Low tire pressure warning lamp on: ON BUZZER Buzzer in combination meter on: ON Test item Content WARNING LAMP This test is able to check to check that the low tire pressure warning lamp turns on. ID REGIST WARNING This test is able to check to check that the buzzer sounds or the low tire pressure warning lamp FLASHER This test is able to check to check that each turn signal lamp turns on. HORN This test is able to check to check that the horn sounds. |