|
|
GW-60 POWER WINDOW SYSTEM Revision: 2006 July 2007 Murano 2. CHECK HARNESS CONTINUITY 1. Turn ignition switch OFF. 2. Disconnect power window main switch and front door lock assembly (driver side) connector. 3. Check continuity between power window main switch connector OK or NG OK >> GO TO 3. NG >> Repair or replace harness. 3. CHECK GROUND CIRCUIT Check continuity between key cylinder switch (driver side) connector OK or NG OK >> GO TO 4. NG >> Repair or replace harness. 4. CHECK DOOR KEY CYLINDER SWITCH Check continuity between key cylinder switch terminals 1, 6 and 5. OK or NG OK >> GO TO 5. NG >> Replace key cylinder switch (driver side). 5. CHECK POWER WINDOW MAIN SWITCH OUTPUT SIGNAL 1. Connect power window main switch connector. 2. Check voltage between power window main switch connector OK or NG OK >> Check the condition of the harness and the connector. NG >> Replace power window main switch. 4 (L) – 1 (L) : Continuity should exist. 6 (R) – 6 (R) : Continuity should exist. PIIA4212E 5 (B) – Ground : Continuity should exist. PIIA4213E Terminals Key position Continuity 1 5 Neutral / Unlock No Lock Yes 6 Neutral / Lock No Unlock Yes PIIA4214E 4 (L) – Ground : Approx. 5V 6 (R) – Ground : Approx. 5V PIIA4211E |