|
|
OIL SEAL EM-93 C D E F G H I J K L M A EM Revision: 2005 August 2005 Murano Removal and Installation of Front Oil Seal ABS003MK REMOVAL 1. Remove the following parts: ● Right side front road wheel and tire ● Splash guard (RH) ● ● Crankshaft pulley; Refer to 2. Remove front oil seal using a suitable tool. CAUTION: Be careful not to damage front timing chain case and crank- INSTALLATION 1. Apply new engine oil to both oil seal lip and dust seal lip of new front oil seal. 2. Install front oil seal. ● Install front oil seal so that each seal lip is oriented as shown ● Using a suitable drift, press-fit until the height of front oil seal – Suitable drift: outer diameter 60 mm (2.36 in), inner diameter CAUTION: ● Be careful not to damage front timing chain case and ● Press-fit straight and avoid causing burrs or tilting oil 3. Install in the reverse order of removal after this step. Removal and Installation of Rear Oil Seal ABS003ML REMOVAL 1. Remove engine assembly from the vehicle, and separate front suspension member, transaxle and trans- . 2. Install engine sub-attachment with engine stand shaft [SST: KV10117001 ( — ) and KV10106500 ( — )] to right side of cylinder block, then lift engine, and mount it onto engine stand [SST: ST0501S000 ( — )]. Refer to . 3. Remove drive plate. Refer to 4. Remove oil pan (upper). Refer to EM-29, "OIL PAN AND OIL STRAINER" SEM829E SEM715A SEM829E |