содержание .. 383 384 385 386 ..
Nissan Murano. Manual - part 385
TOUCH SENSOR
DLK-151
< DTC/CIRCUIT DIAGNOSIS >
[WITH INTELLIGENT KEY SYSTEM]
C
D
E
F
G
H
I
J
L
M
A
B
DLK
N
O
P
TOUCH SENSOR
RH
RH : Description
INFOID:0000000009719089
The touch sensor RH is installed on the right edge of the back door, and it detects any trapped foreign material
in the back door during the auto close operation and at the closure operation.
RH : Component Function Check
INFOID:0000000009719090
1.
CHECK FUNCTION
Check touch sensor RH (“TOUCH SEN RH”) in Data Monitor mode.
Is the inspection result normal?
YES
>> Touch sensor RH is OK.
NO
>> Refer to
DLK-151, "RH : Diagnosis Procedure"
RH : Diagnosis Procedure
INFOID:0000000009719091
1.
CHECK AUTOMATIC BACK DOOR CONTROL UNIT OUTPUT
1.
Turn ignition switch OFF.
2.
Disconnect touch sensor RH connector.
3.
Check voltage between touch sensor RH harness connector and ground.
Is the inspection result normal?
YES
>> GO TO 3.
NO
>> GO TO 2.
2.
CHECK TOUCH SENSOR RH CIRCUIT
1.
Disconnect automatic back door control unit connector.
2.
Check continuity between automatic back door control unit harness connector and touch sensor RH har-
ness connector.
3.
Check continuity between automatic back door control unit harness connector and ground.
Is the inspection result normal?
YES
>> Replace automatic back door control unit. Refer to
DLK-368, "Removal and Installation"
.
NO
>> Repair or replace harness.
3.
CHECK TOUCH SENSOR RH GROUND CIRCUIT
Monitor item
Condition
Status
TOUCH SEN RH
Touch sensor RH
Other than below
OFF
Detect obstruction
ON
(+)
(–)
Voltage (V)
(Approx.)
Touch sensor RH
Connector
Terminal
D164
1
Ground
6
Automatic back door control unit
Touch sensor RH
Continuity
Connector
Terminal
Connector
Terminal
B8
16
D164
1
Existed
Automatic back door control unit
Ground
Continuity
Connector
Terminal
B8
16
Not existed