содержание .. 1236 1237 1238 1239 ..
Nissan Murano. Manual - part 1238
B2195 ANTI-SCANNING
SEC-49
< DTC/CIRCUIT DIAGNOSIS >
[WITH INTELLIGENT KEY SYSTEM]
C
D
E
F
G
H
I
J
L
M
A
B
SEC
N
O
P
B2195 ANTI-SCANNING
Description
INFOID:0000000009722747
When ignition switch is turned ON, BCM performs ID verification with ECM. If ID verification that is out of the
specified specification is detected, BCM prohibits further ID verification and engine cranking.
DTC Logic
INFOID:0000000009722748
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.
PERFORM DTC CONFIRMATION PROCEDURE
1.
Turn ignition switch ON under the following conditions.
-
Selector lever is in the P or N position
-
Do not depress brake pedal
2.
Check “Self-diagnostic result” using CONSULT.
Is DTC detected?
YES
>> Refer to
NO
>> INSPECTION END.
Diagnosis Procedure
INFOID:0000000009722749
1.
CHECK SELF-DIAGNOSTIC RESULT-1
1.
Perform “Self-diagnostic result” of BCM using CONSULT.
2.
Erase DTC.
3.
Perform DTC Confirmation Procedure. Refer to
.
Is DTC 2195 detected?
YES
>> GO TO 2.
NO
>> INSPECTION END
2.
CHECK EQUIPMENT OF THE VEHICLE
Check that unspecified accessory part related to engine start is not installed.
Is unspecified accessory part related to engine start installed?
YES
>> GO TO 3.
NO
>> Replace BCM. Refer to
BCS-98, "Removal and Installation"
3.
CHECK SELF-DIAGNOSTIC RESULT-2
1.
Obtain the customers approval to remove unspecified accessory part related to engine start, and then
remove it.
2.
Perform “Self-diagnostic result” of BCM using CONSULT.
3.
Erase DTC.
4.
Perform DTC Confirmation Procedure. Refer to
.
Is DTC 2195 detected?
YES
>> Replace BCM. Refer to
BCS-98, "Removal and Installation"
NO
>> INSPECTION END
DTC No.
Trouble diagnosis
name
DTC detecting condition
Possible cause
B2195
ANTI-SCANNING
ID verification between BCM and ECM that is out of
the specified specification is detected
ID verification request out of the
specified specification