|
|
содержание .. 2104 2105 2106 2107 ..
TM-382 < DTC/CIRCUIT DIAGNOSIS > [CVT: RE0F10D] P2813 SELECT SOLENOID P2813 SELECT SOLENOID DTC Description INFOID:0000000010622569 DTC DETECTION LOGIC NOTE: → ON → driv- ing → OFF”. POSSIBLE CAUSE Select solenoid valve FAIL-SAFE • When a malfunction occurs on the low oil pressure side DTC CONFIRMATION PROCEDURE CAUTION: Be careful of the driving speed. 1. PREPARATION BEFORE WORK If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P2813 SELECT SOLENOID When any of 1, or 2 is satisfied: When all the following conditions are established three times in 1DC - Precondition • DTC other than the applicable DTC is not detected. • Throttle position: More than 6.27 deg. • Vehicle speed: Less than 3 km/h (1 MPH) • CVT fluid temperature: More than 20 ° C (68 ° F) • Selector lever: Other than P, N • Turbine speed when performed N → D, N (P) → R: More than 500 rpm • TCM power supply voltage: More than 11 V - Detection time • N → D: 0.4 seconds • N → R: 0.3 seconds • P → R: 0.3 seconds 2. When all of the following conditions are satisfied and this state is - The counting of time continues while all of the following conditions • Selector lever: Other than P, N • Vehicle speed: Less than 3 km/h (1 MPH) • Differences between primary pulley speed and secondary speed: • Clutch instructions pressure: 0.95 MPa or more • Differences between turbine speed and input speed: Less than 200 • Turbine speed – speed: More than 450 rpm • DTC other than the applicable DTC is not detected. • TCM power supply voltage: More than 11 V |