|
|
TM-338 < DTC/CIRCUIT DIAGNOSIS > [CVT: RE0F10D] P0848 TRANSMISSION FLUID PRESSURE SEN/SW B Is the inspection result normal? YES >> Check intermittent incident. Refer to GI-41, "Intermittent Incident" . NO >> GO TO 2. 2. CHECK SECONDARY PRESSURE SENSOR POWER CIRCUIT 1. Turn ignition switch OFF. 2. Connect TCM connector. 3. Disconnect CVT unit connector. 4. Turn ignition switch ON. 5. Check voltage between CVT unit harness connector terminal and ground. Is the inspection result normal? YES >> GO TO 3. NO >> Repair or replace malfunctioning parts. 3. CHECK SECONDARY PRESSURE SENSOR SIGNAL CIRCUIT Check voltage between CVT unit harness connector terminal and ground. Is the inspection result normal? YES >> There is malfunction of secondary pressure sensor. Replace transaxle assembly. Refer to 415, "Removal and Installation" . NO >> Repair or replace malfunctioning parts. + − Condition Voltage TCM Connector Terminal F2 16 Ground • After engine warm up 1.23 – 1.25 V + − Voltage (Approx.) CVT unit Connector Terminal F58 22 Ground 5.0 V + − Voltage (Approx.) CVT unit Connector Terminal F58 14 Ground 0 V |