Nissan Qashqai J11. Manual - part 567

FUEL TANK

FL-13

< REMOVAL AND INSTALLATION >

[HRA2DDT]

C

D

E

F

G

H

I

J

K

L

M

A

FL

N

P

O

2.

Start engine and rev it up and make sure there are no fuel leaks at the fuel system tube and hose connec-
tions.

FL-14

< SERVICE DATA AND SPECIFICATIONS (SDS) 

[HRA2DDT]

SERVICE DATA AND SPECIFICATIONS (SDS)

SERVICE DATA AND SPECIFICATIONS (SDS)

SERVICE DATA AND SPECIFICATIONS (SDS)

Fuel Tank

INFOID:0000000010418991

Standard and Limit

Fuel tank capacity

Approximate 55   (12-1/8 Imp gal)

Fuel recommendation

Refer to 

GI-35, "Fuel"

PRECAUTIONS

FL-15

< PRECAUTION >

[MR20DD]

C

D

E

F

G

H

I

J

K

L

M

A

FL

N

P

O

PRECAUTION

PRECAUTIONS

General Precautions

INFOID:0000000010683781

WARNING:

When replacing fuel line parts, be sure to observe the following.
• Put a “CAUTION: FLAMMABLE” sign in the workshop.
• Be sure to work in a well ventilated area and furnish workshop with a CO

2

 fire extinguisher. 

• Never smoke while servicing fuel system. Keep open flames and sparks away from the work area.

CAUTION:

• Use gasoline required by the regulations for octane number. Refer to 

GI-35, "Fuel"

.

• Before removing fuel line parts, perform out the following procedures:
- Put drained fuel in an explosion-proof container and put the lid on securely. Keep the container in

safe area.

- Release fuel pressure from the fuel lines. Refer to 

ECH-121, "Work Procedure"

.

- Disconnect the battery cable from the negative terminal. 
• Always replace O-ring and clamps with new ones.
• Never kink or twist tubes when they are being installed.
• Never tighten hose clamps excessively to avoid damaging hoses. 
• After installing tubes, check there is no fuel leakage at connections in the following steps.
- Apply fuel pressure to fuel lines with turning ignition switch “ON” (with engine stopped). Then check

for fuel leakage at connections.

- Start engine and rev it up and check for fuel leakage at connections.
• Use only a genuine NISSAN fuel filler cap as a replacement. If an incorrect fuel filler cap is used, the

“MI” may come on.

FL-16

< PREPARATION >

[MR20DD]

PREPARATION

PREPARATION

PREPARATION

Special Service Tools

INFOID:0000000010683799

Tool number
Tool name

Description

KV99104700
Lock ring wrench

Removing and installing lock ring

ZZA0122D