|
|
EC9-176 < DTC/CIRCUIT DIAGNOSIS > [R9M] B1901 DC/DC CONVERTER B1901 DC/DC CONVERTER DTC Logic INFOID:0000000010309075 DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1. PRECONDITIONING If the other DTC Confirmation Procedure is performed right before this procedure, the ignition switch must be >> GO TO 2. 2. PERFORM DTC CONFIRMATION PROCEDURE-1 1. Turn ignition switch ON and wait at least 3 seconds. 2. Check DTC. Is DTC detected? YES >> Proceed to EC9-176, "Diagnosis Procedure" . NO >> GO TO 3. 3. PERFORM DTC CONFIRMATION PROCEDURE-2 With CONSULT 1. Start the engine and warm it up to normal operating temperature. 2. Press start/stop OFF switch and check that the switch indicator is ON. 3. Select “AUTO STOP START” in “ACTIVE TEST” mode of “ENGINE” using CONSULT. 4. Touch “START” and operate stop/start system. (engine stop.) 5. Touch “CANCEL” and restart the engine. 6. Check DTC. Without CONSULT 1. Activate stop/start system. Refer to EC9-39, "STOP/START SYSTEM : System Description (M/T models)" EC9-47, "STOP/START SYSTEM : System Description (CVT models)" CAUTION: Always drive vehicle at a safe speed. 2. Restart the engine. 3. Check DTC. Is DTC detected? YES >> Proceed to EC9-176, "Diagnosis Procedure" . NO >> INSPECTION END Diagnosis Procedure INFOID:0000000010309076 1. CHECK FUSE 1. Turn ignition switch OFF. 2. Check that the following fuse is not fusing. Is the fuse fusing? DTC CONSULT screen terms (Trouble diagnosis content) DTC detecting condition Possible cause B1901 — DC/DC converter detects power supply • Harness and connectors (DC/DC converter power supply input 2 cir- • DC/DC converter Fuse No. Capacity F/L-N 30 A |