Nissan Qashqai J11. Manual - part 1786

WW-22

< SYSTEM DESCRIPTION >

DIAGNOSIS SYSTEM (BCM)

DIAGNOSIS SYSTEM (BCM)

COMMON ITEM

COMMON ITEM : CONSULT Function (BCM - COMMON ITEM)

INFOID:0000000010503209

APPLICATION ITEM

CONSULT performs the following functions via CAN communication with BCM.

SYSTEM APPLICATION

BCM can perform the following functions for each system.
NOTE:
It can perform the diagnosis modes except the following for all sub system selection items.

×

: Applicable item

NOTE:
*: This item is displayed, but not used.

FREEZE FRAME DATA (FFD)

The BCM records the following vehicle condition at the time a particular DTC is detected, and displays on
CONSULT.

Diagnosis mode

Function Description

Work Support

Changes the setting for each system function.

Self Diagnostic Result

Displays the diagnosis results judged by BCM.

CAN Diag Support Monitor

Monitors the reception status of CAN communication viewed from BCM.

Data Monitor

The BCM input/output signals are displayed.

Active Test

The signals used to activate each device are forcibly supplied from BCM.

Ecu Identification

The BCM part number is displayed.

Configuration

• Read and save the vehicle specification.
• Write the vehicle specification when replacing BCM.

System

Sub system selection item

Diagnosis mode

Work Support

Data Monitor

Active Test

Door lock

DOOR LOCK

×

×

Rear window defogger

REAR DEFOGGER

×

×

Warning chime

BUZZER

×

×

Exterior lamp

HEAD LAMP

×

×

×

Interior room lamp control

INT LAMP

×

Wiper and washer

WIPER

×

×

×

Turn signal and hazard warning lamps

FLASHER

×

×

—

AIR CONDITONER*

×

×

Intelligent Key system

INTELLIGENT KEY

×

×

×

Combination switch

COMB SW

×

Body control system

BCM

×

NVIS - NATS

IMMU

×

Interior room lamp battery saver

BATTERY SAVER

×

Back door open

TRUNK

×

Vehicle security

THEFT ALM

×

×

RAP

RETAINED PWR

×

Remote keyless entry system

MULTI REMOTE ENT

×

×

Signal buffer system

SIGNAL BUFFER

×

×

DIAGNOSIS SYSTEM (BCM)

WW-23

< SYSTEM DESCRIPTION >

C

D

E

F

G

H

I

J

K

M

A

B

WW

N

O

P

WIPER

WIPER : CONSULT Function - WIPER

INFOID:0000000010430967

WORK SUPPORT

*

1

: For models without light & rain sensor

*

2

: For models with light & rain sensor

*

3

: Factory setting for Europe, Russia or South Africa

*

4

: Factory setting except for Europe, Russia or South Africa

*

5

: Factory setting for all destination

DATA MONITOR

NOTE:
The following table includes information (items) inapplicable to this vehicle. For information (items) applicable
to this vehicle, refer to CONSULT display items.

CONSULT screen item

Indication/Unit

Description

BATTERY VOLTAGE

V

Battery voltage of the moment a particular DTC is detected.

VEHICLE SPEED

km/h

Vehicle speed of the moment a particular DTC is detected.

EXTERNAL TEMP

°

C

External temperature of the moment a particular DTC is detected

VEHICLE COND

—

NOTE:
This item is displayed, but cannot be use this item.

DOOR LOCK STATUS

—

NOTE:
This item is displayed, but cannot be use this item.

POWER SUPPLY 
COUNTER

min

Displays the cumulative time from the time that the battery terminal is connected.

Service item

Setting item

Description

WIPER SPEED SET-

TING*

1

On*

3

Linked with vehicle speed
(Front wiper intermittent time linked with the vehicle speed and 
wiper volume dial position.)

The setting of front wiper 
INT operation can be 
changed.

Off*

4

Not linked with vehicle speed
(Front wiper intermittent time linked with the wiper volume dial 
position.)

RAIN SENSOR*

2

On*

5

Linked with light & rain sensor
(Front wiper intermittent time linked with the light & rain sensor, 
vehicle speed, and wiper volume dial position)

The setting of front wiper 
AUTO operation can be 
changed

Off

Not linked with light & rain sensor
(Front wiper intermittent time linked with the vehicle speed and 
wiper volume dial position)

FR RR DRIP

On*

5

Front wiper drop wipe and rear wiper drop wipe operation ON

The setting of drop wipe 
operation can be 
changed

Off

Front wiper drop wipe and rear wiper drop wipe operation OFF

REAR WIPER LINK 
WITH REVERSE 
SETTING

On

 Rear wiper operation linked with reverse ON

The setting of rear wiper 
operation linked with re-
verse can be changed

Off*

5

 Rear wiper operation linked with reverse OFF

Monitor Item

[Unit]

Description

PUSH SW
[Off/On]

The switch status input from push-button ignition switch.

VEH SPEED 1
[km/h]

Displays the value of the vehicle speed signal received from combination meter via CAN com-
munication.

WW-24

< SYSTEM DESCRIPTION >

DIAGNOSIS SYSTEM (BCM)

*: For models without headlamp washer switch, this item is indicated but is not used.

ACTIVE TEST

*: For models without headlamp washer, this item is indicated but is not used.

FR WIPER HI
[Off/On]

Status of each switch judged by BCM using the combination switch reading function.

FR WIPER LOW
[Off/On]

FR WASHER SW
[Off/On]

FR WIPER INT
[Off/On]

FR WIPER STOP
[Off/On]

Displays the status of the front wiper stop position signal received from IPDM E/R via CAN 
communication.

INT VOLUME
[1 

−

 7] 

Status of each switch judged by BCM using the combination switch reading function.

RR WIPER ON
[Off/On]

Status of each switch judged by BCM using the combination switch reading function.

RR WIPER INT
[Off/On]

RR WASHER SW
[Off/On]

RR WIPER STOP
[Off/On]

Displays the status of the rear wiper stop position signal received from rear wiper motor.

H/L WSR SW*
[Off/On]

Status of headlamp washer switch judged by BCM.

RAIN SENSOR
[OFF/LOW/HIGH/SPLASH/NG]

Request signal from rain sensor detected by BCM is displayed.

Monitor Item

[Unit]

Description

Test item

Operation

Description

FR WIPER

Hi

Operates the front wiper HI operation.

Lo

Operates the front wiper LO operation.

INT

Operates the front wiper INT/AUTO operation.

Off

Stops the front wiper operation.

RR WIPER

On

Operates the rear wiper operation.

Off

Stops the rear wiper operation.

HEADLAMP WASHER*

On

Operates the headlamp washer operation.

DIAGNOSIS SYSTEM (IPDM E/R)

WW-25

< SYSTEM DESCRIPTION >

C

D

E

F

G

H

I

J

K

M

A

B

WW

N

O

P

DIAGNOSIS SYSTEM (IPDM E/R)

CONSULT Function (IPDM E/R)

INFOID:0000000010503210

APPLICATION ITEM

CONSULT performs the following functions via CAN communication with IPDM E/R.

SELF DIAGNOSTIC RESULT

Refer to 

PCS-37, "DTC Index"

.

Freeze Frame Data (FFD)

The IPDM E/R records the vehicle condition at the time a particular DTC is detected, and displays on CON-
SULT.

DATA MONITOR

NOTE:
The following table includes information (items) inapplicable to this vehicle. For information (items) applicable
to this vehicle, refer to CONSULT display items.

Diagnosis mode

Description

Self Diagnostic Result

Displays the diagnosis results judged by IPDM E/R.

Data Monitor

Displays the real-time input/output data from IPDM E/R input/output data.

Work Support

Changes the setting for each system function.

Active Test

IPDM E/R can provide a drive signal to electronic components to check their operations.

Ecu Identification

Allows confirmation of IPDM E/R part number.

Configuration

• Read and save the vehicle specification.
• White the vehicle specification when replacing IPDM E/R.

CAN Diag Support Monitor

The results of transmit/receive diagnosis of CAN communication can be read.

Monitor Item

[Unit]

Description

REVERSE SIGNAL
[Open/Close]

Displays the status of the transmission range switch (CVT) or reverse/neutral position 
switch (M/T) judged by IPDM E/R.

IGN RELAY
[Open/Close]

Displays the status of the ignition relay judged by IPDM E/R.

PUSH SW
[Open/Close]

Displays the status of the push-button ignition switch judged by IPDM E/R.

NEUTRAL SW
[Open/Close]

Displays the status of the reverse/neutral position switch (M/T) judged by IPDM E/R.

INTERLOCK/PNP SW
[Open/Close]

Displays the status of the transmission range switch (CVT) judged by IPDM E/R.

OIL PRESSURE SW
[Open/Close]

Displays the status of the oil pressure switch judged by IPDM E/R.

LED H/L RH STATUS
[Open/Close]

Displays the LED headlamp (right) ON/OFF status judged by IPDM E/R.
NOTE:
This item is monitored only on the vehicle with LED headlamp.

LED H/L LH STATUS
[Open/Close]

Displays the LED headlamp (left) ON/OFF status judged by IPDM E/R.
NOTE:
This item is monitored only on the vehicle with LED headlamp.

HOOD SW
[Open/Close]

Displays the status of the hood switch judged by IPDM E/R.

COMPRESSOR
[Off/On]

Displays the compressor drive status judged by IPDM E/R.

H/L WASHER PUMP
[Off/On]

Displays the status of the headlamp washer pump judged by IPDM E/R.