Nissan Juke (2016 year). Service Repair Manual - part 676

 

  Index      Manuals     Nissan Juke (2016 year) - Service and Repair Manual

 

Search            copyright infringement  

 

 

 

 

 

 

 

 

Content      ..     674      675      676      677     ..

 

 

Nissan Juke (2016 year). Service Repair Manual - part 676

 

 

SERVICE DATA AND SPECIFICATIONS (SDS)

VTL-17

< SERVICE DATA AND SPECIFICATIONS (SDS) 

C

D

E

F

G

H

J

K

L

M

A

B

VTL

N

O

P

SERVICE DATA AND SPECIFICATIONS (SDS)

SERVICE DATA AND SPECIFICATIONS (SDS)

In-cabin microfilter

INFOID:0000000012199157

Replacement interval

MA-7, "Introduction of Periodic Maintenance"

Revision: November 2015

2016 JUKE

WCS

WCS-1

DRIVER INFORMATION & MULTIMEDIA

C

D

E

F

G

H

I

J

K

L

M

B

SECTION 

WCS

A

O

P

CONTENTS

WARNING CHIME SYSTEM

PRECAUTION ...............................................

3

PRECAUTIONS ...................................................

3

Precaution for Supplemental Restraint System 
(SRS) "AIR BAG" and "SEAT BELT PRE-TEN-
SIONER" ...................................................................

3

Precautions for Removing Battery Terminal  .............

3

SYSTEM DESCRIPTION  ..............................

5

COMPONENT PARTS  ........................................

5

Component Parts Location ........................................

5

Component Description .............................................

5

Combination Meter ....................................................

6

SYSTEM ..............................................................

7

WARNING CHIME SYSTEM  .......................................

7

WARNING CHIME SYSTEM : System Diagram .......

7

WARNING CHIME SYSTEM : System Description 

......

7

WARNING CHIME SYSTEM : Fail-Safe ...................

7

LIGHT REMINDER WARNING CHIME  .......................

8

LIGHT REMINDER WARNING CHIME : System 
Diagram .....................................................................

8

LIGHT REMINDER WARNING CHIME : System 
Description ................................................................

9

SEAT BELT WARNING CHIME  ................................

10

SEAT BELT WARNING CHIME : System Diagram 

....

10

SEAT BELT WARNING CHIME : System Descrip-
tion ..........................................................................

10

PARKING BRAKE RELEASE WARNING CHIME ....

11

PARKING BRAKE RELEASE WARNING CHIME 
: System Diagram ....................................................

11

PARKING BRAKE RELEASE WARNING CHIME 
: System Description  ...............................................

12

DIAGNOSIS SYSTEM (COMBINATION 
METER) ..............................................................

14

CONSULT Function .................................................

14

DIAGNOSIS SYSTEM (BCM)  ...........................

18

COMMON ITEM  .........................................................

18

COMMON ITEM : CONSULT Function (BCM - 
COMMON ITEM)  .....................................................

18

BUZZER .....................................................................

19

BUZZER : CONSULT Function (BCM - BUZZER) ....

19

ECU DIAGNOSIS INFORMATION ..............

21

COMBINATION METER  ...................................

21

Reference Value ......................................................

21

Fail-Safe ..................................................................

27

DTC Index  ...............................................................

28

BCM (BODY CONTROL MODULE)  .................

30

List of ECU Reference .............................................

30

WIRING DIAGRAM ......................................

31

WARNING CHIME SYSTEM .............................

31

Wiring Diagram ........................................................

31

BASIC INSPECTION  ...................................

37

DIAGNOSIS AND REPAIR WORKFLOW  ........

37

Work Flow ................................................................

37

DTC/CIRCUIT DIAGNOSIS  .........................

39

POWER SUPPLY AND GROUND CIRCUIT  ....

39

COMBINATION METER  ............................................

39

COMBINATION METER : Diagnosis Procedure  .....

39

METER BUZZER CIRCUIT  ...............................

40

Component Function Check  ....................................

40

Diagnosis Procedure ..............................................

40

SEAT BELT BUCKLE SWITCH SIGNAL CIR-
CUIT ..................................................................

41

Revision: November 2015

2016 JUKE

WCS

PRECAUTIONS

WCS-3

< PRECAUTION >

C

D

E

F

G

H

I

J

K

L

M

B

A

O

P

PRECAUTION

PRECAUTIONS

Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT 
PRE-TENSIONER"

INFOID:0000000012201459

The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along

with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain

types of collision. This system includes seat belt switch inputs and dual stage front air bag modules. The SRS

system uses the seat belt switches to determine the front air bag deployment, and may only deploy one front

air bag, depending on the severity of a collision and whether the front occupants are belted or unbelted.

Information necessary to service the system safely is included in the “SRS AIR BAG” and “SEAT BELT” of this

Service Manual.

WARNING:

Always observe the following items for preventing accidental activation.

• To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death in

the event of a collision that would result in air bag inflation, it is recommended that all maintenance

and repair be performed by an authorized NISSAN/INFINITI dealer.

• Improper repair, including incorrect removal and installation of the SRS, can lead to personal injury

caused by unintentional activation of the system. For removal of Spiral Cable and Air Bag Module,

see “SRS AIR BAG”.

• Never use electrical test equipment on any circuit related to the SRS unless instructed to in this Ser-

vice Manual. SRS wiring harnesses can be identified by yellow and/or orange harnesses or harness

connectors.

PRECAUTIONS WHEN USING POWER TOOLS (AIR OR ELECTRIC) AND HAMMERS

WARNING:

Always observe the following items for preventing accidental activation.

• When working near the Air Bag Diagnosis Sensor Unit or other Air Bag System sensors with the

ignition ON or engine running, never use air or electric power tools or strike near the sensor(s) with

a hammer. Heavy vibration could activate the sensor(s) and deploy the air bag(s), possibly causing

serious injury.

• When using air or electric power tools or hammers, always switch the ignition OFF, disconnect the

battery or batteries, and wait at least 3 minutes before performing any service.

Precautions for Removing Battery Terminal

INFOID:0000000012926050

When disconnecting the battery terminal, pay attention to the following.

• Always use a 12V battery as power source.

• Never disconnect battery terminal while engine is running.

• When removing the 12V battery terminal, turn OFF the ignition

switch and wait at least 30 seconds.

• For vehicles with the engine listed below, remove the battery termi-

nal after a lapse of the specified time:

NOTE:

ECU may be active for several tens of seconds after the ignition switch is turned OFF. If the battery terminal

is removed before ECU stops, then a DTC detection error or ECU data corruption may occur.

• After high-load driving, if the vehicle is equipped with the V9X engine, turn the ignition switch OFF and wait

for at least 15 minutes to remove the battery terminal.

NOTE:

D4D engine

: 20 minutes

YS23DDT

: 4 minutes

HRA2DDT

: 12 minutes

YS23DDTT

: 4 minutes

K9K engine

: 4 minutes

ZD30DDTi

: 60 seconds

M9R engine

: 4 minutes

ZD30DDTT

: 60 seconds

R9M engine

: 4 minutes

V9X engine

: 4 minutes

YD25DDTi

: 2 minutes

SEF289H

Revision: November 2015

2016 JUKE

WCS-4

< PRECAUTION >

PRECAUTIONS

• Turbocharger cooling pump may operate in a few minutes after the ignition switch is turned OFF.

• Example of high-load driving

- Driving for 30 minutes or more at 140 km/h (86 MPH) or more.

- Driving for 30 minutes or more on a steep slope.

• For vehicles with the 2-batteries, be sure to connect the main battery and the sub battery before turning ON

the ignition switch.

NOTE:

If the ignition switch is turned ON with any one of the terminals of main battery and sub battery discon-

nected, then DTC may be detected.

• After installing the 12V battery, always check "Self Diagnosis Result" of all ECUs and erase DTC.

NOTE:

The removal of 12V battery may cause a DTC detection error.

Revision: November 2015

2016 JUKE

WCS

COMPONENT PARTS

WCS-5

< SYSTEM DESCRIPTION >

C

D

E

F

G

H

I

J

K

L

M

B

A

O

P

SYSTEM DESCRIPTION

COMPONENT PARTS

Component Parts Location

INFOID:0000000012201461

Component Description

INFOID:0000000012201462

1.

Parking brake switch 

2.

Combination meter

3.

ABS actuator and electric unit (con-
trol unit)
Refer to 

BRC-9, "Component Parts 

Location"

.

4.

BCM
Refer to 

BCS-5, "BODY CONTROL 

SYSTEM : Component Parts Loca-
tion"

5.

Seat belt buckle switch (driver side)

 

JSNIA3559ZZ

Unit

Description

Combination meter

• Receives a buzzer output signal from the BCM with CAN communication line and sounds the 

buzzer.

• Judges whether the parking brake is released from the vehicle speed signal received from the 

ABS actuator and electric unit (control unit) with CAN communication line and the parking 
brake switch signal from the parking brake switch, and sounds the buzzer if necessary.

BCM

Based on the signals received from various units and switches, transmits the buzzer output sig-
nal to the combination meter via CAN communication.

ABS actuator and electric unit 
(control unit)

Transmits the vehicle speed signal to combination meter via CAN communication.

Seat belt buckle switch (driver 
side)

Transmits a seat belt buckle switch signal (driver side) to the combination meter.

Combination switch
(Lighting switch)

Transmits the combination switch signal to BCM.

Front door switch (driver side)

Transmits the driver side door switch signal to BCM.

Parking brake switch

Transmits the parking brake switch signal to the combination meter.

Revision: November 2015

2016 JUKE

WCS-6

< SYSTEM DESCRIPTION >

COMPONENT PARTS

Combination Meter

INFOID:0000000012201463

The buzzer (1) for the warning chime system is integrated in the

combination meter.

JSNIA3231ZZ

Revision: November 2015

2016 JUKE

WCS

SYSTEM

WCS-7

< SYSTEM DESCRIPTION >

C

D

E

F

G

H

I

J

K

L

M

B

A

O

P

SYSTEM

WARNING CHIME SYSTEM
WARNING CHIME SYSTEM : System Diagram

INFOID:0000000012201464

WARNING CHIME SYSTEM : System Description

INFOID:0000000012201465

COMBINATION METER

The combination meter sounds the alarm buzzer installed in the combination meter when receiving the buzzer

output signal transmitted from each unit. 

BCM

BCM receives signals from various units and transmits a buzzer output signal to the combination meter via

CAN communication if it judges that the warning buzzer should be activated.

WARNING CHIME FUNCTION LIST

WARNING CHIME SYSTEM : Fail-Safe

INFOID:0000000012201466

FAIL-SAFE

The combination meter activates the fail-safe control if CAN communication with each unit is malfunctioning.

JSNIA3116GB

Warning functions

Out line

Warning judgment unit

Refer to

Light reminder warning chime

The warning chime sounds when the ignition 
switch is in OFF or ACC position with the com-
bination switch (lighting switch) in the 1st or 
2nd position and the driver side door open.

BCM

WCS-9, 
"LIGHT RE-
MINDER 
WARNING 
CHIME : Sys-
tem Descrip-
tion"

Seat belt warning chime

The warning chime sounds when the driver 
seat belt is unfastened with the ignition switch 
in ON position.

BCM

WCS-10, 
"SEAT BELT 
WARNING 
CHIME : Sys-
tem Descrip-
tion"

Parking brake release warning chime

The warning chime sounds when the ignition 
switch is in ON position with the parking brake 
in operation and the vehicle speed 7 km/h (4.3 
MPH) or more.

Combination meter

WCS-12, 
"PARKING 
BRAKE RE-
LEASE WARN-
ING CHIME : 
System De-
scription"

Revision: November 2015

2016 JUKE

 

 

 

 

 

 

 

Content      ..     674      675      676      677     ..