Nissan Juke (2016 year). Service Repair Manual - part 113

>> Repair or replace harness.

CHECK INTERMITTENT INCIDENT

DLK-87, "Diagnosis Procedure"

>> INSPECTION END

(+)

(–)

Condition

Signal

(Reference value)

Remote keyless entry receiver

Connector

Terminal

M75

Ground

Waiting

12 V

Press the Intelligent
Key lock or unlock
button

JMMIA0572GB

BCM

Remote keyless entry receiver

Continuity

Connector

Terminal

Connector

Terminal

M68

M75

Existed

BCM

Ground

Continuity

Connector

Terminal

M68

Not existed

Revision: November 2015

2016 JUKE

SHIFT P WARNING LAMP

DLK-87

< DTC/CIRCUIT DIAGNOSIS >

[WITH INTELLIGENT KEY SYSTEM]

DLK

SHIFT P WARNING LAMP

Component Function Check

INFOID:0000000012196654

CHECK FUNCTION

1. Select “INTELLIGENT KEY” of “BCM” using CONSULT.

2. Select “LCD” in “ACTIVE TEST” mode.

3. Check that the function operates normally according to the following conditions.

Is the inspection result normal?

YES

>> Shift P warning lamp is OK.

>> Refer to

Diagnosis Procedure

INFOID:0000000012196655

CHECK SHIFT P WARNING LAMP

MWI-21, "On Board Diagnosis Function"

Is the inspection result normal?

YES

>> GO TO 2.

>> Repair or replace the malfunctioning parts.

CHECK INTERMITTENT INCIDENT

DLK-88, "Diagnosis Procedure"

>> INSPECTION END

Monitor item

Status

LCD

SFT P

Shift P warning lamp

Turns ON

Revision: November 2015

2016 JUKE

DLK-88

< DTC/CIRCUIT DIAGNOSIS >

[WITH INTELLIGENT KEY SYSTEM]

UNLOCK SENSOR

UNLOCK SENSOR

Component Function Check

INFOID:0000000012196656

CHECK FUNCTION

1. Select “INTELLIGENT KEY” of “BCM” using CONSULT.

2. Select “UNLK SEN -DR” in “DATA MONITOR” mode.

3. Check that the function operates normally according to the following conditions.

Is the inspection result normal?

YES

>> Unlock sensor is OK.

>> Refer to

Diagnosis Procedure

INFOID:0000000012196657

CHECK BCM OUTPUT SIGNAL

1. Turn ignition switch OFF.

2. Disconnect front door lock assembly (driver side) connector.

3. Check signal between front door lock assembly (driver side) harness connector and ground using oscillo-

scope.

Is the inspection result normal?

YES

>> GO TO 3.

>> GO TO 2.

CHECK UNLOCK SENSOR CIRCUIT

1. Disconnect BCM connector.

2. Check continuity between BCM harness connector and front door lock assembly (driver side) harness

connector.

3. Check continuity between BCM harness connector and ground.

Is the inspection result normal?

YES

>> Replace BCM. Refer to

Monitor item

Condition

Status

UNLK SEN -DR

Driver side door

Lock

OFF

Unlock

(+)

(–)

Signal

(Reference value)

Front door lock assembly (driver side)

Connector

Terminal

D38

Ground

PKIB4960J

BCM

Front door lock assembly (driver side)

Continuity

Connector

Terminal

Connector

Terminal

M68

D38

Existed

BCM

Ground

Continuity

Connector

Terminal

M68

Not existed

Revision: November 2015

2016 JUKE

UNLOCK SENSOR

DLK-89

< DTC/CIRCUIT DIAGNOSIS >

[WITH INTELLIGENT KEY SYSTEM]

DLK

>> Repair or replace harness.

CHECK UNLOCK SENSOR GROUND CIRCUIT

Check continuity between front door lock assembly (driver side) harness connector and ground.

Is the inspection result normal?

YES

>> GO TO 4.

>> Repair or replace harness.

CHECK UNLOCK SENSOR

DLK-89, "Component Inspection"

Is the inspection result normal?

YES

>> GO TO 5.

>> Replace front door lock assembly (driver side).

CHECK INTERMITTENT INCIDENT

>> INSPECTION END

Component Inspection

INFOID:0000000012196658

CHECK UNLOCK SENSOR

1. Turn ignition switch OFF.

2. Disconnect front door lock assembly (driver side) connector.

3. Check continuity between front door lock assembly (driver side) terminals.

Is the inspection result normal?

YES

>> INSPECTION END

>> Replace front lock assembly (driver side).

Front door lock assembly (driver side)

Ground

Continuity

Connector

Terminal

D38

Existed

Front door lock assembly (driver side)

Condition

Continuity

Terminal

Driver side door

Unlock

Existed

Lock

Not existed

Revision: November 2015

2016 JUKE

DLK-90

< SYMPTOM DIAGNOSIS >

[WITH INTELLIGENT KEY SYSTEM]

DOOR DOES NOT LOCK/UNLOCK WITH DOOR LOCK AND UNLOCK SWITCH

SYMPTOM DIAGNOSIS

DOOR DOES NOT LOCK/UNLOCK WITH DOOR LOCK AND UNLOCK
SWITCH

ALL DOOR
ALL DOOR : Description

INFOID:0000000012196659

All doors do not lock/unlock using door lock and unlock switch.

ALL DOOR : Diagnosis Procedure

INFOID:0000000012196660

CHECK DOOR LOCK AND UNLOCK SWITCH

Check door lock and unlock switch.

DLK-73, "Component Function Check"

Is the inspection result normal?

YES

>> GO TO 2.

>> Repair or replace the malfunctioning parts.

CHECK DOOR LOCK ACTUATOR

Check front door lock assembly (driver side).

DLK-68, "DRIVER SIDE : Component Function Check"

Is the inspection result normal?

YES

>> GO TO 3.

>> Repair or replace the malfunctioning parts.

REPLACE BCM

1. Replace BCM. Refer to

2. Confirm the operation after replacement.
Is the result normal?

YES

>> INSPECTION END

>> Check intermittent incident. Refer to

DRIVER SIDE
DRIVER SIDE : Description

INFOID:0000000012196661

Driver side door does not lock/unlock using door lock and unlock switch.

DRIVER SIDE : Diagnosis Procedure

INFOID:0000000012196662

CHECK DOOR LOCK ACTUATOR

Check front door lock assembly (driver side).

DLK-68, "DRIVER SIDE : Component Function Check"

Is the inspection result normal?

YES

>> GO TO 2.

>> Repair or replace the malfunctioning parts.

REPLACE BCM

1. Replace BCM. Refer to

2. Confirm the operation after replacement.
Is the result normal?

YES

>> INSPECTION END

>> Check intermittent incident. Refer to

PASSENGER SIDE

Revision: November 2015

2016 JUKE

DOOR DOES NOT LOCK/UNLOCK WITH DOOR LOCK AND UNLOCK SWITCH

DLK-91

< SYMPTOM DIAGNOSIS >

[WITH INTELLIGENT KEY SYSTEM]

DLK

PASSENGER SIDE : Description

INFOID:0000000012196663

Passenger side door does not lock/unlock using door lock and unlock switch.

PASSENGER SIDE : Diagnosis Procedure

INFOID:0000000012196664

CHECK DOOR LOCK ACTUATOR

Check front door lock assembly (passenger side).

DLK-69, "PASSENGER SIDE : Component Function Check"

Is the inspection result normal?

YES

>> GO TO 2.

>> Repair or replace the malfunctioning parts.

REPLACE BCM

1. Replace BCM. Refer to

2. Confirm the operation after replacement.
Is the result normal?

YES

>> INSPECTION END

>> Check intermittent incident. Refer to

REAR LH
REAR LH : Description

INFOID:0000000012196665

Rear LH side door does not lock/unlock using door lock and unlock switch.

REAR LH : Diagnosis Procedure

INFOID:0000000012196666

CHECK DOOR LOCK ACTUATOR

Check rear door lock assembly LH.

DLK-70, "REAR LH : Component Function Check"

Is the inspection result normal?

YES

>> GO TO 2.

>> Repair or replace the malfunctioning parts.

REPLACE BCM

1. Replace BCM. Refer to

2. Confirm the operation after replacement.
Is the result normal?

YES

>> INSPECTION END

>> Check intermittent incident. Refer to

REAR RH
REAR RH : Description

INFOID:0000000012196667

Rear RH side door does not lock/unlock using door lock and unlock switch.

REAR RH : Diagnosis Procedure

INFOID:0000000012196668

CHECK DOOR LOCK ACTUATOR

Check rear door lock assembly RH.

DLK-71, "REAR RH : Component Function Check"

Is the inspection result normal?

YES

>> GO TO 2.

>> Repair or replace the malfunctioning parts.

REPLACE BCM

1. Replace BCM. Refer to

Revision: November 2015

2016 JUKE

DLK-92

< SYMPTOM DIAGNOSIS >

[WITH INTELLIGENT KEY SYSTEM]

DOOR DOES NOT LOCK/UNLOCK WITH DOOR LOCK AND UNLOCK SWITCH

2. Confirm the operation after replacement.
Is the result normal?

YES

>> INSPECTION END

>> Check intermittent incident. Refer to

DLK-18, "REMOTE KEYLESS ENTRY FUNCTION : System Description"

Revision: November 2015

2016 JUKE

DOOR DOES NOT LOCK/UNLOCK WITH DOOR REQUEST SWITCH

DLK-93

< SYMPTOM DIAGNOSIS >

[WITH INTELLIGENT KEY SYSTEM]

DLK

DOOR DOES NOT LOCK/UNLOCK WITH DOOR REQUEST SWITCH

ALL DOOR REQUEST SWITCHES
ALL DOOR REQUEST SWITCHES : Description

INFOID:0000000012196669

All doors do not lock/unlock using all door request switches.

ALL DOOR REQUEST SWITCHES : Diagnosis Procedure

INFOID:0000000012196670

CHECK REMOTE KEYLESS ENTRY FUNCTION

Check remote keyless entry function.
Does door lock/unlock with Intelligent Key button?

YES

>> GO TO 2.

>> Refer to

CHECK “LOCK/UNLOCK BY I-KEY” SETTING IN “WORK SUPPORT”

1. Select “INTELLIGENT KEY” of “BCM” using CONSULT.

2. Select “LOCK/UNLOCK BY I-KEY” in “WORK SUPPORT” mode.

3. Check “LOCK/UNLOCK BY I-KEY” in “WORK SUPPORT”.

DLK-28, "INTELLIGENT KEY : CONSULT Function (BCM - INTELLIGENT KEY)"

Is the inspection result normal?

YES

>> GO TO 3.

>> Set “LOCK/UNLOCK BY I-KEY” in “WORK SUPPORT”.

CHECK DOOR SWITCH

Check door switch.

DLK-77, "Component Function Check"

Is the inspection result normal?

YES

>> GO TO 4.

>> Repair or replace the malfunctioning parts.

CHECK INSIDE KEY ANTENNA

Check inside key antenna.

• Instrument center: Refer to

DLK-49, "DTC Logic"

• Luggage room: Refer to

DLK-51, "DTC Logic"

Is the inspection result normal?

YES

>> GO TO 5.

>> Repair or replace the malfunctioning parts.

CHECK OUTSIDE KEY ANTENNA

Check outside key antenna.

• Driver side: Refer to

DLK-55, "DTC Logic"

• Passenger side: Refer to

DLK-53, "DTC Logic"

• Rear bumper: Refer to

DLK-57, "DTC Logic"

Is the inspection result normal?

YES

>> GO TO 6.

>> Repair or replace the malfunctioning parts.

REPLACE BCM

1. Replace BCM. Refer to

2. Confirm the operation after replacement.
Is the result normal?

YES

>> INSPECTION END

>> Check intermittent incident. Refer to