|
|
P1572 ASCD BRAKE SWITCH EC-1109 < DTC/CIRCUIT DIAGNOSIS > [MR EXCEPT FOR NISMO RS MODELS] C D E F G H I J K L M A EC N P O 3. PERFORM DTC CONFIRMATION PROCEDURE FOR MALFUNCTION B 1. Drive the vehicle for at least 5 consecutive seconds as per the following conditions. CAUTION: Always drive vehicle at a safe speed. NOTE: This procedure may be conducted with the drive wheels lifted in the shop or by driving the vehicle. If a road test is expected to be easier, it is unnecessary to lift the vehicle. 2. Check DTC. YES >> Proceed to EC-1113, "Diagnosis Procedure" NO >> INSPECTION END Diagnosis Procedure INFOID:0000000012198633 1. CHECK OVERALL FUNCTION-I With CONSULT 1. Turn ignition switch ON. 2. Select “BRAKE SW1” in “DATA MONITOR” mode of “ENGINE” using CONSULT. 3. Check “BRAKE SW1” indication as per the following conditions. Without CONSULT 1. Turn ignition switch ON. 2. Check the voltage between ECM harness connector terminals as per the following. Is the inspection result normal? YES >> GO TO 2. NO >> GO TO 3. 2. CHECK OVERALL FUNCTION-II With CONSULT Select “BRAKE SW2” and check indication as per the following conditions. Without CONSULT Check the voltage between ECM harness connector terminals as per the following conditions. Vehicle speed More than 30 km/h (19 mph) Selector lever Suitable position Driving location Depress the brake pedal for more Monitor item Condition Indication BRAKE SW1 Brake pedal Slightly depressed OFF Fully released ON ECM Condition Voltage (Approx.) Connector + – Terminal E19 140 152 Brake pedal Slightly depressed 0 V Fully released Battery voltage Monitor item Condition Indication BRAKE SW2 Brake pedal Slightly depressed ON Fully released OFF |