|
|
Content .. 1332 1333 1334 1335 ..
TM-526 < DTC/CIRCUIT DIAGNOSIS > [CVT: RE0F10D] P2813 SELECT SOLENOID P2813 SELECT SOLENOID DTC Logic INFOID:0000000012201220 DTC DETECTION LOGIC NOTE: DC stands for “DRIVING CYCLE” and indicates a series of driving cycle of “Ignition switch OFF → ON → driv- ing → OFF”. DTC CONFIRMATION PROCEDURE 1. PREPARATION BEFORE WORK If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test. DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition Possible causes P2813 SELECT SOLENOID When any of 1, or 2 is satisfied: When all the following conditions are es- - Precondition • DTC other than the applicable DTC is not • Throttle position: More than 6.27 deg. • Vehicle speed: Less than 3 km/h (1 • CVT fluid temperature: More than 20 °C (68 °F) • Selector lever: Other than P, N • Turbine speed when performed N → D, N (P) → R: More than 500 rpm • TCM power supply voltage: More than 11 - Detection time • N → D: 0.4 seconds • N → R: 0.3 seconds • P → R: 0.3 seconds 2. When all of the following conditions are - The counting of time continues while all • Selector lever: Other than P, N • Vehicle speed: Less than 3 km/h (1 • Differences between primary pulley • Clutch instructions pressure: 0.95 MPa • Differences between turbine speed and • Turbine speed – speed: More than 450 • DTC other than the applicable DTC is • TCM power supply voltage: More than 11 Select solenoid valve |