Nissan Tiida C11. Manual - part 160

DLK-50

< FUNCTION DIAGNOSIS >

[WITH I-KEY, WITHOUT SUPER LOCK]

DIAGNOSIS SYSTEM (BCM)

DIAGNOSIS SYSTEM (BCM)

COMMON ITEM

COMMON ITEM : CONSULT-III Function (BCM - COMMON ITEM)

INFOID:0000000001396502

APPLICATION ITEM

CONSULT-III performs the following functions via CAN communication with BCM.

SYSTEM APPLICATION

BCM can perform the following functions for each system.
NOTE:
It can perform the diagnosis modes except the following for all sub system selection items.

DOOR LOCK

DOOR LOCK : CONSULT-III Function (BCM - DOOR LOCK)

INFOID:0000000001396503

BCM CONSULT-III FUNCTION

CONSULT-III performs the following functions via CAN communication with BCM.

Diagnosis mode

Function Description

WORK SUPPORT

Changes the setting for each system function.

SELF-DIAG RESULTS

Displays the diagnosis results judged by BCM. Refer to 

XX-XX, "*****"

.

CAN DIAG SUPPORT MNTR

Monitors the reception status of CAN communication viewed from BCM.

DATA MONITOR

The BCM input/output signals are displayed.

ACTIVE TEST

The signals used to activate each device are forcibly supplied from BCM.

ECU IDENTIFICATION

The BCM part number is displayed.

CONFIGURATION

• Enables to read and save the vehicle specification.
• Enables to write the vehicle specification when replacing BCM.

System

Sub system selection item

Diagnosis mode

WORK SUPPORT

DATA MONITOR

ACTIVE TEST

—

BCM

×

Door lock

DOOR LOCK

×

×

×

Rear window defogger

REAR DEFOGGER

×

×

Warning chime

BUZZER

×

×

Interior room lamp timer

INT LAMP

×

×

×

Remote keyless entry system

MULTI REMOTE ENT

×

×

×

Exterior lamp

HEAD LAMP

×

×

×

Wiper and washer

WIPER

×

×

×

Turn signal and hazard warning lamps

FLASHER

×

×

Air conditioner

AIR CONDITONER

×

Intelligent Key system

INTELLIGENT KEY

×

Combination switch

COMB SW

×

Immobilizer

IMMU

×

×

Interior room lamp battery saver

BATTERY SAVER

×

×

×

Trunk open

TRUNK

×

Vehicle security system

THEFT ALM

×

×

×

Signal buffer system

SIGNAL BUFFER

×

×

PTC heater system

PTC HEATER

×

×

DIAGNOSIS SYSTEM (BCM)

DLK-51

< FUNCTION DIAGNOSIS >

[WITH I-KEY, WITHOUT SUPER LOCK]

C

D

E

F

G

H

I

J

L

M

A

B

DLK

N

O

P

DATA MONITOR

ACTIVE TEST

WORK SUPPORT

INTELLIGENT KEY

INTELLIGENT KEY : CONSULT-III Function (BCM - INTELLIGENT KEY)

INFOID:0000000001396504

BCM CONSULT-III FUNCTION

Diagnosis mode

Function Description

WORK SUPPORT

Changes the setting for each system function.

DATA MONITOR

The BCM input/output signals are displayed.

ACTIVE TEST

The signals used to activate each device are forcibly supplied from BCM.

Monitor Item

Condition

IGN ON SW

Indicates [ON/OFF] condition of ignition switch in ON position.

ACC ON SW

Indicates [ON/OFF] condition of ignition switch in ACC position.

PUSH SW

Indicates [ON/OFF] condition of ignition knob switch.

KEY ON SW

Indicates [ON/OFF] condition of key switch.

CDL LOCK SW

Indicates [ON/OFF] condition of door lock and unlock switch.

CDL UNLOCK SW

Indicates [ON/OFF] condition of door lock and unlock switch.

DOOR SW-DR

Indicates [ON/OFF] condition of front door switch (driver side).

DOOR SW-AS

Indicates [ON/OFF] condition of front door switch (passenger side).

DOOR SW-RR

Indicates [ON/OFF] condition of rear door switch RH.

DOOR SW-RL

Indicates [ON/OFF] condition of rear door switch LH.

BACK DOOR SW

Indicates [ON/OFF] condition of back door switch.

BD/TR OPNR SW

Indicates [ON/OFF] condition of back door/trunk opener switch.

I-KEY LOCK

Indicates [ON/OFF] condition of lock signal from Intelligent Key.

I-KEY UNLOCK

Indicates [ON/OFF] condition of unlock signal from Intelligent Key.

UNLOCK WITH DR

This item is indicated, but not monitored.

UNLOCK SHOCK

Indicates [ON/OFF] condition of signal from air bag diagnosis unit.
• ON: During the unlock operation interlock with air bag.
• OFF: Other than above.

SHOCK SENSOR

Indicates [NOMAL/ON/OFF] condition of circuit between BCM and air bag diagnosis sensor unit.
• NORMAL: Ignition switch ON. (BCM is receiving normal condition signal from air bag diagno-

sis sensor unit.)

• ON: During the receiving of air bag deployment signal from air bag diagnosis sensor unit.
• OFF: After the receiving of air bag deployment signal from air bag diagnosis sensor unit.

VEHICLE SPEED

Displays the vehicle speed signal received from combination meter by numerical value [km/h].

Test item

Description

DOOR LOCK IND

This test is able to check door lock indicator (built in door lock and unlock switch on center 
console) operation [ON/OFF].

DOOR LOCK

This test is able to check door lock operation [ALL LOCK/ALL UNLOCK/DR UNLOCK/
OTHER UNLOCK].

Test item

Description

SECURITY DOOR LOCK SET

Anti hijack function mode can be changed in this mode.
• ON: Anti hijack mode is active.
• OFF: Anti hijack mode is inactive.

DLK-52

< FUNCTION DIAGNOSIS >

[WITH I-KEY, WITHOUT SUPER LOCK]

DIAGNOSIS SYSTEM (BCM)

CONSULT-III performs the following functions via CAN communication with BCM.

DATA MONITOR

TRUNK

TRUNK : CONSULT-III Function (BCM - TRUNK)

INFOID:0000000001396505

APPLICATION ITEM

CONSULT-III performs the following functions via CAN communication with BCM.

DATA MONITOR

ACTIVE TEST

Diagnosis mode

Function Description

DATA MONITOR

The BCM input/output signals are displayed.

Monitor Item

Condition

IGN ON SW

Indicates [ON/OFF] condition of ignition switch in ON position.

ACC ON SW

Indicates [ON/OFF] condition of ignition switch in ACC position.

KEY ON SW

Indicates [ON/OFF] condition of key switch.

PUSH SW

Indicates [ON/OFF] condition of ignition knob switch.

I-KEY LOCK

Indicates [ON/OFF] condition of lock signal from Intelligent Key.

I-KEY UNLOCK

Indicates [ON/OFF] condition of unlock signal from Intelligent Key.

Diagnosis mode

Function Description

DATA MONITOR

The BCM input/output signals are displayed.

ACTIVE TEST

The signals used to activate each device are forcibly supplied from Intelligent Key unit.

Monitor Item

Condition

IGN ON SW

Indicates [ON/OFF] condition of ignition switch in ON position.

KEY ON SW

Indicates [ON/OFF] condition of key switch.

PUSH SW

Indicates [ON/OFF] condition of ignition knob switch.

TRNK OPNR SW

Indicates [ON/OFF] condition of back door/trunk opener switch.

VEHICLE SPEED

Displays the vehicle speed signal received from combination meter by numerical value 
[km/h].

Test item

Description

TRUNK/GLASS HATCH

This test is able to check back door actuator/trunk release solenoid operation [ON/OFF]. 

DIAGNOSIS SYSTEM (INTELLIGENT KEY UNIT)

DLK-53

< FUNCTION DIAGNOSIS >

[WITH I-KEY, WITHOUT SUPER LOCK]

C

D

E

F

G

H

I

J

L

M

A

B

DLK

N

O

P

DIAGNOSIS SYSTEM (INTELLIGENT KEY UNIT)

CONSULT-III Function (INTELLIGENT KEY)

INFOID:0000000001396506

APPLICATION ITEM

CONSULT-III performs the following functions via CAN communication with Intelligent Key unit.

WORK SUPPORT

SELF-DIAG RESULT

Refer to 

DLK-171, "DTC Index"

.

DATA MONITOR

Diagnosis mode

Function Description

WORK SUPPORT

Changes the setting for each system function.

SELF-DIAG RESULTS

Displays the diagnosis results judged by Intelligent Key unit.

CAN DIAG SUPPORT MNTR

Monitors the reception status of CAN communication viewed from Intelligent Key unit.

DATA MONITOR

The Intelligent Key unit input/output signals are displayed.

ACTIVE TEST

The signals used to activate each device are forcibly supplied from Intelligent Key unit.

ECU IDENTIFICATION

The Intelligent Key unit part number is displayed.

Support item

Description

Selection item

Condition

CONFIRM KEY FOB ID

It can check whether Intelligent Key ID code 
is registered or not.

—

—

TAKE OUT FROM WINDOW WARN

Take away warning chime (from window) 
mode can be changed.

ON

Active

OFF

Inactive

LOW BATT OF KEY FOB WARN

Intelligent Key low battery warning mode can 
be changed.

ON

Active

OFF

Inactive

KEYLESS FUNCTION

Door lock function with Intelligent Key can be 
changed.

ON

Active

OFF

Inactive

ANSWER BACK FUNCTION

Buzzer reminder operation can be changed.

ON

Active

OFF

Inactive

SELECTIVE UNLOCK FUNCTION

Anti-hijack mode can be changed.

ON

Active

OFF

Inactive

HAZARD ANSWER BACK

Hazard reminder operation mode can be 
changed.

Refer to 

DLK-45

.

ANSWER BACK WITH I-KEY LOCK

Buzzer reminder operation (lock operation) 
mode by each door request switch can be 
changed. 

BUZZER

Active

OFF

Inactive

ANSWER BACK WITH I-KEY UNLOCK

Buzzer reminder operation (unlock operation) 
mode by each door request switch can be 
changed.

BUZZER

Active

OFF

Inactive

AUTO RELOCK TIMER

Auto door lock operation mode can be 
changed.

OFF

Inactive

2 min

Active

ENGINE START BY I-KEY

Engine start function (by Intelligent Key) 
mode can be changed. 

ON

Active

OFF

Inactive

LOCK/UNLOCK BY I-KEY

Door lock function by door request switch can 
be changed. 

ON

Active

OFF

Inactive