Mitsubishi Outlander XL. Manual - part 1108

NO:

 Diagnose the combination meter. Refer to GOUP 54Ab,

Troubleshooting P.54Ab-40.

STEP 5. Check combination meter connector C-03 and
audio visual navigation unit connector C-10 for loose,
corroded or damaged terminals, or terminals pushed back
in the connector.

Q:Is  combination  meter  connector  C-03  or  audio  visual

navigation unit connector C-10 in good condition?

YES:

 Go to Step 6.

NO:

 Repair or replace the damaged component(s). Refer to

GROUP 00E, Harness Connector Inspection P.00E-2.

STEP 6. Check the wiring harness between combination
meter connector C-03 (terminal 20) and audio visual
navigation unit connector C-10 (terminal 13).

｠

Check the communication lines for open circuit.

NOTE: 

Also check intermediate connector C-17 for loose,

corroded, or damaged terminals, or terminals pushed back in
the connector. If intermediate connector C-17 is damaged,
repair or replace the connector as described in GROUP 00E,
Harness Connector Inspection P.00E-2.

Q:Is  the  wiring  harness  between  combination  meter

connector C-03 (terminal 20) and audio visual navigation

unit connector C-10 (terminal 13) in good condition?

YES:

 Go to Step 7.

NO:

 The wiring harness may be damaged or the connector

(s) may have loose, corroded or damaged terminals, or
terminals pushed back in the connector. Repair the wiring
harness as necessary.

STEP 7. Substitute a known good audio visual navigation
unit, and check the trouble symptom.
Check whether the navigation screen is normal.

Q:Is the navigation screen normal?

YES:

 Replace the audio visual navigation unit.

NO:

 Replace the combination meter.

Inspection Procedure 6: AM and/or FM station(s) cannot be received.

M15410800221USA0000010000

COMMENTS ON TROUBLE SYMPTOM
The roof antenna, the antenna feeder cable or the audio visual
navigation unit may be defective.

PROBABLE CAUSES

｠

Malfunctions of roof antenna

｠

Malfunctions of antenna feeder cable

｠

Malfunctions of audio visual navigation unit

AUDIO AND NAVIGATION SYSTEM

54B-113

DIAGNOSIS

DIAGNOSIS

STEP 1. Check the frequency of the FM multiplex broadcast
station which you selected.
Check whether the station frequency selected is being broadcast
in stereo.

Q:Is  the  station  frequency  selected  being  broadcast  in

stereo?

YES:

 Go to Step 2.

NO:

 Select a FM multiplex broadcast station.

STEP 2. Check the reception status of the station frequency.
Check whether the station frequency selected is strong enough
for good reception.

Q:Is  the  station  frequency  strong  enough  for  good

reception?

YES:

 Go to Step 3.

NO:

 Go to Step 5.

STEP 3. Confirmation in MMCS service mode
Perform "Network/Connect Line Check" at the MMCS service
mode to check that the communication and wire connection with
the FM stereo receiver are in good condition.

Q:Are the communication and wire connection with the FM

stereo receiver in good condition?

YES:

 Go to Step 4.

NO:

 Go to Step 5.

STEP 4. Substitute a known good audio visual navigation
unit, and check whether it operates normally.

Q:Is the check result normal?

YES:

 Replace the audio visual navigation unit.

NO:

 Go to Step 5.

STEP 5. Check the roof antenna.
Check whether the roof antenna is damaged.

Q:Is the roof antenna damaged?

YES:

 Replace the roof antenna.

NO:

 Replace the antenna feeder cable.

Inspection Procedure 7: GPS signal cannot be received.

M15410800096USA0000010000

COMMENTS ON TROUBLE SYMPTOM
The GPS antenna or the audio visual navigation unit
may be defective.

PROBABLE CAUSES

｠

Malfunctions of GPS antenna

｠

Malfunctions of audio visual navigation unit

DIAGNOSIS

54B-114

AUDIO AND NAVIGATION SYSTEM

DIAGNOSIS

STEP 1. Confirmation in MMCS service mode
Perform  "Network/Connect  Line  Check"  in  the  MMCS  service
mode to check that the communication and wire connection with
the GPS antenna are OK. (Refer to P.54B-64.)

Q:Is the check result normal?

YES:

 Go to Step 2.

NO:

 Go to Step 4.

STEP 2. Check for the vehicle's current position.
Check that the vehicle is parked on a well-ventilated place.

Q:Is the vehicle parked on a well-ventilated place?

YES:

 Go to Step 3.

NO:

 Move the vehicle to a well-ventilated area.

STEP 3. Confirming GPS signal reception

(1)

Turn the ignition switch to the "ACC" position.

(2)

Wait for 15 minutes, and then check whether GPS signal can
be received.

Q:Can GPS signal be received?

YES:

 The procedure is complete. (There is no failure)

NO:

 Go to Step 4.

STEP 4. Substitute a known good GPS antenna, and check
the trouble symptom.
When a known good GPS antenna is substituted, check whether
GPS signal can be received.

Q:Is the check result normal?

YES:

 Replace the GPS antenna.

NO:

 Replace the audio visual navigation unit.

Inspection Procedure 8: No DVD (video disk) cannot be played.

M15410800105USA0000010000

COMMENTS ON TROUBLE SYMPTOM
The DVD (video disk) or the audio visual navigation
unit may be defective.

PROBABLE CAUSES

｠

Defective DVD (video disk)

｠

Malfunctions of audio visual navigation unit

DIAGNOSIS

STEP 1. Confirmation in MMCS service mode
Perform  "Network/Connect  Line  Check"  in  the  MMCS  service
mode, and check whether "OK" is displayed under "DVD drive".
(Refer to P.54B-64.)

Q:Is "OK" displayed under "DVD drive" item?

YES:

 Go to Step 2.

NO:

 Replace the audio visual navigation unit.

STEP 2. Check that a DVD's recorded surface faces down.
Check that a DVD's recorded surface faces down.

AUDIO AND NAVIGATION SYSTEM

54B-115

DIAGNOSIS

Q:Is  the  DVD  inserted  with  its  recorded  surface  facing

down?

YES:

 Go to Step 3.

NO:

 Check the DVD's recorded surface, and insert the DVD

again. (For a one-sided disk, its recorded surface should
face down)

STEP 3. Check a DVD (video disk) to be inserted.
Check whether the DVD (video disk) is an authorized one.

Q:Is the DVD (video disk) an authorized one?

YES:

 Go to Step 4.

NO:

 Use an authorized DVD (video disk).

STEP 4. Check a DVD (video disk) to be inserted.
Check that there are no stains or scratches on the DVD (video
disk).

Q:Are  there  any  stains  or  scratches  on  the  DVD  (video

disk)?

YES:

 Clean or deburr the disk, or use a scratch and burr-

free disk. Then insert the disk again.

NO:

 Go to Step 5.

STEP 5. Substitute a known good DVD (video disk), and
check the trouble symptom.
When a known good DVD (video disk) is loaded, check whether
it is played normally.

Q:Is the check result normal?

YES:

 Replace the DVD (video disk).

NO:

 Go to Step 6.

STEP 6. Check the trouble symptom.
When a DVD (video disk) is loaded, check whether it is played
normally.

Q:Is the DVD (video disk) played normally?

YES:

 The procedure is complete.

NO:

 Replace the audio visual navigation unit.

Inspection Procedure 9: Image of a DVD (video disk) is played, but no sound is played.

M15410800106USA0000010000

COMMENTS ON TROUBLE SYMPTOM
The DVD (video disk) or the audio visual navigation
unit may be defective.

PROBABLE CAUSES

｠

Defective DVD (video disk)

｠

Malfunctions of audio visual navigation unit

DIAGNOSIS

STEP 1. Check whether other sounds are emitted.
Check whether sound other than DVD (video disk) is emitted.

Q:Is sound other than DVD (video disk) emitted?

YES:

 Go to Step 2.

54B-116

AUDIO AND NAVIGATION SYSTEM

DIAGNOSIS