|
|
ENGINE AND EMISSION CONTROL -- Body 1-6 Wrapping work No. Process Operation Content 1 Continuous peeling of film The film is peeled off. 2 Water rinse Sand and dust are removed from the vehicle body and it is 3 Parts where the film is to be reapplied are There should be no leftover adhesive, swelling or discolor- 4 Treatment of parts where film is to be Treat the defects on the parts where film is to be reapplied. If 5 Reapplication 1. Basically, the parts where the film is to be applied should 2. Apply the film from the lower portion of the body, working 3. As necessary, cut the film at the various parts such as Cautions Apply the film with the body at a temperature of 10 ~ 40 _C. (Workability is good in this temperature range.) 2. If the outside surface of the film (the side with no adhesive) is brought into direct contact with the paint film and 3. Air bubbles and wrinkles do not have a particularly bad influence on the pain film, but every effort should be 4. To prevent intrusion of rainwater, be sure to press down the overlapping portions and cut ends of the film se- 3. EXTERIOR (1) Visually inspect the entire exterior. 1) Paint condition (2) Coated surfaces maintenance Touch up minor paint chips and flaws. NOTE |