Mitsubishi Lancer Evolution X. Manual - part 473
REAR ROLL STOPPER AND CROSSMEMBER
TSB Revision
POWER PLANT MOUNT
32-13
<<C>> FRONT AXLE CROSSMEMBER
ASSEMBLY REMOVAL
1. Jack up and support the font axle crossmember, remove the
front axle crossmember mounting bolt.
2. Check the hoses and harnesses for roughness, and then
remove the front axle crossmember assembly with the rear
roll stopper and the steering gear and linkage installed.
INSTALLATION SERVICE POINTS
.
>>A<< JOINT COVER GROMMET INSTALLATION
Install the joint cover grommet by aligning the projection of the
steering gear and linkage assembly with the mating mark of the
joint cover grommet as shown in the figure.
.
>>B<< STABILIZER BAR/STABILIZER
BUSHING/STABILIZER BAR BRACKET
INSTALLATION
Install the stabilizer bar, the stabilizer bushing and the stabilizer
bar bracket as shown in the figure.
.
AC606181
Piece of wood
Transmission jack
AB
AC606182AD
Joint cover grommet
Steering gear and linkage assembly
Protrusion
part
Mating mark
AC609899
AB
Stabilizer bushing
Front axle
crossmember
Stabilizer bar
bracket
Slit
Front