Mitsubishi Lancer Evolution X. Manual - part 214

PARKING BRAKE LINING AND DRUM

TSB Revision

PARKING BRAKES

36-15

REMOVAL SERVICE POINTS

.

<<A>> REAR BRAKE CALIPER ASSEMBLY 
REMOVAL

1.  Remove the rear brake caliper assembly with the brake 

hose kept attached.

2. Secure the removed rear brake caliper assembly with a wire 

or other similar material at a position where it will not 
interfere with the removal and installation works.

.

<<B>>REAR BRAKE DISK REMOVAL

If the rear brake disk removal is difficult, install bolts (M8 x 1.25 
mm) shown in the figure, and tighten them evenly and gradually 
to remove the rear brake disk.

INSTALLATION SERVICE POINTS

.

>>A<< WASHER INSTALLATION

Install the washer in the direction shown in the illustration.

.

•

Rear wheel hub assembly (Refer to 
GROUP 27 − Rear Axle Hub 
Assembly 

P.27-35

.)

22. Backing plate

Removal steps (Continued)

AC707776AB

Bolts (M8 x 1.25 mm)

AC304675AD

Shoe and lining assembly

Chamber 
retainer

Washer

Parking brake 
operating lever

PARKING BRAKE LINING AND DRUM

TSB Revision

PARKING BRAKES

36-16

>>B<< CHAMBER RETAINER INSTALLATION

Use pliers or a similar tool to close the chamber retainer end 
onto the pin.

.

>>C<< ADJUSTER ASSEMBLY INSTALLATION

Install the adjuster assembly so that the shoe adjusting bolt is 
positioned at the rear of the vehicle for the left side, and at the 
front of the vehicle for the right side.

.

AC000926AJ

Pin of shoe and lining assembly

Chamber retainer

AC706498AB

Shoe adjusting bolt

Shoe adjusting bolt

<Right side wheel>

<Left side wheel>

Front of the vehicle

Rear of the vehicle

PARKING BRAKE LINING AND DRUM

TSB Revision

PARKING BRAKES

36-17

>>D<< SHOE-TO-ANCHOR SPRING 
INSTALLATION

The shoe-to-anchor springs are not interchangeable because 
their spring loads are different. The one with blue paint must be 
installed to the vehicle front, and the other with yellow paint to 
the vehicle rear.

INSPECTION

M1361002600538

BRAKE LINING THICKNESS CHECK

1. Measure the lining thickness at the most worn area.

Standard value: 2.8 mm (0.11 inch)
Limit: 1.0 mm (0.04 inch)

2. If the thickness is less than the limit value, replace the right 

and left shoe and lining assemblies as a set.

BRAKE DRUM INSIDE DIAMETER CHECK

1. Measure the inside diameter of the brake drum at two 

positions or more.

Standard value: 190.0 mm (7.48 inch)
Limit: 191.0 mm (7.52 inch)

2. If the inside diameter is more than limit value or if there is 

excessive wear, replace the brake disc.

AC706198 AB

Front of the vehicle

Blue paint

Yellow paint

Blue paint

Yellow paint

<Right side wheel>

<Left side wheel>

ACX00708

ACX00709

NOTES