|
|
SPECIFICATIONS TSB Revision ENGINE OVERHAUL <3.0L ENGINE> 11D-63 SEALANTS M1113000500060 Piston ring end gap mm (in) No.1 0.30 − 0.45 (0.012 − 0.017) 0.8 (0.03) No.2 0.45 − 0.60 (0.018 − 0.023) 0.8 (0.03) Oil ring side 0.20 − 0.60 (0.008 − 0.023) 1.0 (0.03) Piston pin outside diameter mm (in) 22.0 (0.87) - Piston pin press-in load N (lbs) (room temperature) 7,350 − 17,200 (1,653 − 3,866) - Crankshaft pin oil clearance mm (in) 0.02 − 0.05 (0.0008 − 0.0019) 0.1 (0.003) Connecting rod big end side clearance mm (in) 0.10 − 0.25 (0.003 − 0.009) 0.4 (0.02) Crankshaft and cylinder block Crankshaft end play mm (in) 0.05 − 0.25 (0.002 − 0.009) 0.3 (0.01) Crankshaft journal outside diameter mm (in) 60 (2.4) - Crankshaft pin outside diameter mm (in) 50 (2.0) - Crankshaft journal oil clearance mm (in) 0.02 − 0.04 (0.0008 − 0.0015) 0.1 (0.003) Piston to cylinder clearance mm (in) 0.02 − 0.04 (0.0008 − 0.0015) - Cylinder block flatness of gasket surface mm (in) 0.05 (0.02) 0.1 (0.003) Cylinder block grinding limit of gasket surface mm - 0.2 (0.008) Cylinder block overall height mm (in) 210.5 (8.29) - Cylinder bore inside diameter mm (in) 91.1 (3.59) - Cylindricity mm (in) 0.01 (0.0003) - ITEM STANDARD VALUE LIMIT ITEM SPECIFIED SEALANT QUANTITY Engine coolant temperature sensor 3M AAD Part No. 8731 or equivalent As required Engine coolant temperature gauge 3M AAD Part No. 8672 or equivalent As required Oil pressure switch 3M AAD Part No. 8672 or equivalent As required Oil pump case MITSUBISHI Genuine part No. MD970389 or As required Oil pan MITSUBISHI Genuine part No. MD970389 or As required Oil seal case MITSUBISHI Genuine part No. MD970389 or As required |