Range Rover Sport. Manual - part 91

 

  Index      Land Rover     Range Rover Sport - service repair manual 2005-2009 year

 

Search            

 

 

 

 

 

 

 

 

 

Content   ..  89  90  91  92   ..

 

 

Range Rover Sport. Manual - part 91

 

 

3 . Check and top-up the Dynamic Response system fluid reservoir.

Maintenance Schedules - Gasoline Engines 

Torque Specifications

Description

Nm lb-ft

Seat frame fixing Torx screws 40

30

Seat belt fixing Torx screws

40

30

Road wheel nuts

140 103

  CAUTION: Unless stated otherwise, the following operations must be carried out at every service interval.

Note that the 'A' and 'B' Service Intervals listed on the 'Maintenance Check Sheet' for vehicles operating under
arduous conditions, vary from those specified for vehicles operating under normal conditions. Reference must
therefore, always be made to the 'Arduous Conditions Maintenance Check Sheet' for vehicles operating under
these conditions.

Under Bonnet View - 4.4 Litre and 4.2 Litre Supercharged

1. Brake fluid reservoir (LH drive illustrated - RH drive on opposite side)
2. Engine oil filler cap
3. Dynamic Response fluid reservoir
4. Engine oil level indicator
5. Windshield washer fluid reservoir
6. Coolant expansion tank
7. Power steering fluid reservoir

Maintenance Operations

Seats and Safety Belts

Front seat frame fixings - Every 2 years or 30,000 miles (48,000 km)

2. Check that the front seat frame fixing Torx screws are secure and that the seat frames show no signs of movement. 

3.Install the trim panels on completion.

Rear seat frame front fixings - Every 2 years or 30,000 miles (48,000 km)

4. Check that the rear seat frame front fixings are secure and that the seat frames show no signs of movement. 

Rear seat frame rear fixings - Every 2 years or 30,000 miles (48,000 km)

6. Fold the seat cushions back on completion.

Front seat controls

7. Check operation of all seat controls.

Safety belts - Every 2 years or 30,000 miles (48,000 km)

8. Fully extend each safety belt and check that it returns unassisted; repeat for all belts.

9. Check entire length of safety belt webbing for signs of fraying or damage; repeat for all belts.

10. Connect each safety belt to the correct buckle, check safety belt buckle and tongue are secure; check that buckle
releases tongue correctly.

11. Check all safety belt and buckle mountings and fixings for security.

 

 

 

 

 

 

 

Content   ..  89  90  91  92   ..