|
|
B163F-FRONT RIGHT TURN CONTROL CIRCUIT LOW (CONTINUED) For a complete wiring diagram Refer to Section 8W. • When Monitored: • With the Turn Signal activated. • Set Condition: • When the FCM detects a LOW condition. Possible Causes (L60) FRONT RIGHT TURN SIGNAL CONTROL CIRCUIT FRONT CONTROL MODULE Diagnostic Test 1. INTERMITTENT CONDITION Turn the ignition on. With the Scan Tool, clear all FCM DTC’s. Turn the Right Turn Signals on. With the Scan Tool read the DTC information. Does the Scan Tool read: B163F-FRONT RIGHT TURN CONTROL CIRCUIT LOW? Yes >> Go To 2 No >> The condition that caused the symptom is currently not present. Inspect the related wiring for a possible intermittent condition. Look for any chafed, pierced, pinched, or partially broken wires. Perform the BODY VERIFICATION TEST - VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CON- 2. L60 FRONT RIGHT TURN SIGNAL CONTROL CIRCUIT Turn the ignition off. Disconnect the FCM C2 harness connector. Disconnect the Right Front Headlamp harness connector. Measure the resistance between ground and the (L60) Front Turn Sig- Is the resistance below 5.0 ohms? Yes >> Repair the (L60) Front Right Turn Signal Control circuit for a short to ground. Perform the BODY VERIFICATION TEST - VER 1. (Refer No >> Replace the Front Control Module in accordance with the service information. Perform the BODY VERIFICATION TEST - VER 1. (Refer 8L - 26 LAMPS/LIGHTING - EXTERIOR - ELECTRICAL DIAGNOSTICS WK |