|
|
LAMP SYSTEMS SERVICE TABLE OF CONTENTS page page DESCRIPTION AND OPERATION REMOVAL AND INSTALLATION AUTO HEADLAMP SENSOR . . . . . . . . . . . . . . . . 16 DESCRIPTION AND OPERATION HEADLAMP SWITCH DESCRIPTION The headlamp switch is integral to the exterior lighting switch, which is part of the left (lighting) OPERATION The exterior lighting switch uses a hard wired 5 volt reference circuit from the BCM, resistor multi- DRL MODULE DESCRIPTION The Daytime Running Lights (Headlamps) System is installed on vehicles manufactured for sale in Can- OPERATION The headlamps are illuminated when the engine is running, headlamp switch off, and the parking brake TAIL/STOP/TURN/BACK-UP LAMPS DESCRIPTION The taillamps on the Grand Cherokee are mounted at the rear of the vehicle, outboard of the rear hatch OPERATION All exterior lighting function are controlled by the multifunction switch. Stop lamp functions are con- REMOVAL AND INSTALLATION AUTO HEADLAMP SENSOR REMOVAL (1) Remove instrument panel top cover. Refer to Group 8E, Instrument Panel for service procedures. (2) Remove screw attaching auto headlamp sensor to instrument panel (Fig. 1). (3) Disengage harness connector from auto head- lamp sensor. (4) Separate auto headlamp sensor from instru- ment panel. INSTALLATION (1) Position auto headlamp sensor on instrument panel. (2) Engage harness connector to auto headlamp sensor. (3) Install screw attaching auto headlamp sensor to instrument panel. (4) Install instrument panel top cover. Refer to Group 8E, Instrument Panel for service procedures. 8L - 16 LAMPS WJ |